NEC LCD1770V, LCD1770NX, LCD1770NXM user manual Specifications, Monitor, MultiSync LCD1770V

Specifications

Monitor		MultiSync® LCD1770V™	Notes
Specifications		Monitor
LCD Module	Diagonal :	17.0 inch	Active matrix; thin film transistor (TFT)
Viewable Image Size :		17.0 inch	liquid crystal display (LCD); 0.264 mm dot
Native Resolution (Pixel Count) :		1280 x 1024	pitch; 250cd/m2 white luminence;
			450:1 contrast ratio, typical
Input Signal	Video :	ANALOG 0.7 Vp-p/75 Ohms
	Sync :	Separate sync. TTL Level
		Horizontal sync. Positive/Negative
		Vertical sync. Positive/Negative
Display Colors		16,194,277	Dependent on display card used.
Maximum	Left/Right :	80°/80° (CR>5)
Viewing Angles	Up/Down :	75°/70° (CR>5)
Synchronization	Horizontal :	31.5 kHz to 81.0 kHz	Automatically
Range	Vertical :	56.0 Hz to 75.0 Hz	Automatically
Resolutions Supported		720 x 400*1 :VGA text	Some systems may not support all modes listed.
		640 x 480*1 @ 60 Hz to 75 Hz
		800 x 600*1 @ 56 Hz to 75 Hz
		832 x 624*1 @ 75 Hz
		1024 x 768*1 @ 60 Hz to 75 Hz
		1152 x 870*1 @ 75 Hz
		1280 x 1024 @ 60 Hz to 75 Hz .......................... NEC-Mitsubishi Electronics Display cites
			recommended resolution at 60 Hz for
			optimal display performance.
Active Display Area	Horizontal :	337.9 mm/13.3 inches
	Vertical :	270.3 mm/10.6 inches
Power Supply		100 Ð 240 V ~ 50/60 Hz
Current Rating		0.7 Ð 0.36A
Dimensions		367.0 mm (W) x 362.5-472.5 mm (H) x 198.0 mm (D)
		14.4 inches (W) x 14.3-18.6 inches (H) x 7.8 inches (D)
Weight		6.0 kg
		13.2 lbs
Environmental Considerations
Operating Temperature :		5°C to 35°C/41°F to 95°F
	Humidity :	30% to 80%
	Feet :	0 to 10,000 Feet
Storage Temperature :		-10°C to 60°C/14°F to 140°F
	Humidity :	10% to 85%
	Feet :	0 to 30,000 Feet

*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.

NOTE: Technical specifications are subject to change without notice.

14

LCD17PISAManual080604.p65 14 8/6/04, 5:15 PM