Chapter 5 Operating SCU | 53 |
The maintenance operations over a single rectifier include: “DC ON/OFF”, “AC ON/OFF” and “Reset”. The operation method is:
①Use “ ” or ” ” to select the rectifier parameter, and “ ” or “ ” to change the rectifier serial No. Then press “ENT” to confirm. The bottom line of the page displays the rectifier ID.
②Use “ ” or “ ” to move the cursor to the maintenance operation area, and “ ” or “ ” to select the value.
If the rectifier voltage is too high, you can select “Reset” to restore the output voltage of that rectifier to normal.
6.There will be prompts as the confirmation of control commands. If the maintenance operation is valid, system will prompt you press “ENT” to confirm and execute the operation, or “ESC” to abort the operation. Otherwise, system will prompt you the operation is invalid, and press “ESC” to quit.
Press ENT to Run
Other Key Quit
No Maintain!
ESC Quit
Press “ESC” to return to the menu of higher level.
5.7 Setting System Parameters
Battery parameters are very important, for they are related to the life of battery. Before delivery, the battery parameters have been initialized. Without any special needs, you only need to reset the battery group number and battery capacity, and accept the defaults for other parameters.
5.7.1Parameter Setting Method
1.At any system information page, press “ENT” to enter the main menu.
MAIN MENU status Maintenance Settings
ACTURA Flex 48330 Power System User Manual