Windows 2000 or Later
Other Methods of Installation
Your printer can also be installed on a Windows 2000 or later network using one of these methods:
■Microsoft TCP/IP Protocol
■Microsoft IPP Port
To monitor or configure your printer, use CentreWare IS with a web browser if your printer is connected to a Windows 2000 or later network with the TCP/IP protocol enabled.
Note: The CentreWare methods are not discussed in this section.
See also:
Printer Management Software on page
Microsoft TCP/IP Protocol
Note: For Windows XP, select Classic Look or the Windows XP procedures will not match the steps below. To select Classic Look, click Start, click Control Panel, and then click Taskbar and Start Menu. Select the Start Menu tab, and then select the Classic Start menu. Click OK.
To verify that TCP/IP is installed:
1.
2.Right-click Local Area Connection, and then click Properties.
3.Click the General tab to verify that Internet Protocol (TCP/IP) is installed.
■If the Internet Protocol (TCP/IP) box is checked, the software is installed.
■If the Internet Protocol (TCP/IP) box is not checked, the software is not installed. Install TCP/IP software using the documentation provided by Microsoft, and then return to this document.
Adding the Printer
To add the printer:
1.On the desktop click Start, and then click Settings.
2.Select one of these options:
■Windows 2000: Click Printers,
■Windows XP or Windows Server 2003: Click Printers and Faxes.
3.Click the Local Printer button, and then click Next.
4.Click the Create a New Port button.
5.Select Standard TCP/IP Port from the New Port Type
6.Click Next.
Phaser® 8560MFP/8860MFP Multifunction Printer