Xerox 8560MFP/8860MFP manual Selecting Tray 2-N Mode, Setting Description Dynamic

Printer Settings

Selecting Tray 2-N Mode

The Tray 2-N Mode setting specifies:

■How Tray 2-N paper type and size are determined when you load paper in the tray but do not select the paper type and size on the control panel.

Setting	Description
Dynamic	■	Uses the settings from the next print job that prints from Tray 2-N to
(Factory default setting)		determine the paper size and type.
Static	■	The paper size and type already set for Tray 2-N stay in effect.

To select the Tray 2-N mode setting, use one of the following options:

■The printer’s control panel

■CentreWare IS

Using the Control Panel

To select a Tray 2-N mode setting on the control panel:

1.Press the System button.

2.Select Paper Tray Setup, and then press the OK button.

3.Select Tray 2-N Mode, and then press the OK button.

4.Select the appropriate setting, and then press the OK button.

Using CentreWare IS

To select a Tray 2-N mode setting using CentreWare IS:

1.Launch your web browser.

2.Enter the printer’s IP address in the browser’s Address field.

3.Click Properties.

4.Select the General folder on the left navigation panel, and then select System Defaults.

5.Select the appropriate setting in the Tray 2-N Mode drop-down list.

6.Click the Save Changes button at the bottom of the page.

Phaser® 8560MFP/8860MFP Multifunction Printer

4-12