Xerox 3 manual Windows 2000 Network, Introduction Preliminary Steps

Page 22

Windows 2000 Network

Windows 2000 Network

Introduction

Preliminary Steps

Your printer can be installed on a Windows 2000 network using one of three methods:

•TCP/IP protocol

•DLC/LLC protocol

•AppleTalk protocol

The Preliminary Steps given below must be accomplished for all printers regardless of the protocol that is being used. Then, the Quick Install Steps will detail the installation based on the protocol used on your network.

The CentreWare DP program on your Printer Management Software CD-ROM can also be used to monitor and configure the printer.

1 Print the Configuration Sheet. Details are in this document in Appendix A: Print The Configuration Sheet. Retain this page for reference.

2 Check the Configuration Sheet and verify that both the desired protocol and connector are enabled.

3 Proceed to the Quick Install Steps for your network protocol.

22 ❖ Quick Network Install Guide

Image 22

Contents DocuPrint Quick Network Install Guide Quick Network Install Guide Contents Contents Purpose of This Document Requirements Additional informationHow to Use this Document Printer System Administrator Guide to correctFound in the printer CD ROM Instruction booklet Windows 95/98 Peer-to-Peer NetworkNetworked Printers NextWindows 95/98 Peer-to-Peer Network Windows 95/98 Peer-to-Peer Network Quick Install Steps To change the group name in a NetBEUI-only network Type yes to confirm the monitor session Windows 95/98 Users Windows NT 4.x Network Introduction Preliminary StepsAdd printer Wizard starts TCP/IP ProtocolClick Add Port Click New Port Printer System Administrator Guide to correct DLC/LLC Protocol Quick Install StepsSelect the Hewlett-Packard Network Port If the printer will not be shared, click Next. To share Select the AppleTalk Printing Devices and click New AppleTalk ProtocolPort CD Drive\instal\winnt40 then click Open Windows 2000 Network Inside the Network and Dial-up Connections window Select Standard TCP/IP Port from the New Port Type Click in the Printer Name or IP Address edit box,Windows 2000 Network Windows 2000 Network DLC/LLC Protocol Select the Hewlett-Packard Network Port from the NewPage. Click Next Printer System Administrator Guide to correct Properties Network and Dial-up Connections window and secectSelect the AppleTalk Printing Devices from the New Next Printer System Administrator Guide to correct Macintosh EtherTalk Network Document in Appendix a Print The ConfigurationSheet Quick Setup Novell NetWare 3.1x, 4.1x NetworksPrinter System Administrator Guide to correct the problem Novell NetWare 3.1x, 4.1x, 5.x Networks OS/2 Warp Server LAN Server Network Are found in the Technical Information GuideOS/2 Warp V4.0 OS/2 Warp Connect Peer-to-Peer Network Unix Network IBM AIXSunos and Solaris Refer to the CentreWare DP user Go to Appendix B Set an IP Address and perform oneAvailable on the Printer Management Software CD-ROM Internet Printer Services Configure your Web Browser Appendix a Print Configuration Sheet For DocuPrint Networked PrintersPress Enter. The Configuration Sheet will be printed RARP/BOOTP Appendix B Set an IP AddressStatic Addressing Appendix B Set an IP Address Dynamic Addressing RARP/BOOTP Dynamic Addressing Dhcp Document entitled Appendix a Print The Configuration Sheet Dynamic Addressing Dhcp or RARP/BOOTP Arp -s x.x.x.x aa-aa-aa-aa-aa-aa CR Type Telnet x.x.x.x CRArp -s ether name 0081aaa no leading zeros RS-6000 X.x nameArpbypass set name 0x00.0x00.0x81.0xa.0xa.0xa AT&T and NCR Appendix B Set an IP Address Quick Network Install Guide

Related manuals

Manual 4 pages 48.38 Kb