Xerox 3 manual Go to Appendix B Set an IP Address and perform one

UNIX Network
Quick Install Steps	1 Print the Configuration Sheet. Details are in this
		document in Appendix A: Print The Configuration
		Sheet.
	2	Check the Configuration Sheet and verify that both
		TCP/IP protocol and proper connector are enabled.
	3	Go to Appendix B: Set an IP Address and perform one of
		the procedures there depending on the manner in which
		you wish to set your printers IP address.
	4	SUNOS and Solaris: Refer to the CentreWare DP user
		Guide for SunOS/Solaris (English only) included on the
		Printer Management Software CD-ROM for CentreWare
		installation and detailed printer setup instructions.
		Other UNIX OS: Load printer drivers and configure the
		printer for one of the Print Models. These drivers are
		available on the Printer Management Software CD-ROM
		or from the Xerox Web site (ftp.xerox.com).
	5	Send a print job to the printer.
	6	Check the print job for print quality. If print quality
		problems exist, use the print quality section of your
		printer System Administrator Guide to correct the
		problem.
	7	If your print job did not print, see the Troubleshooting
		section for your operating system in the Technical

Information Guide to correct the problem.

40 ❖ Quick Network Install Guide