Xerox 3 manual Document entitled Appendix a Print The Configuration Sheet

Page 50

Appendix B: Set an IP Address

7

8

9

Perform the steps contained in the section of this

document entitled Appendix A: Print The Configuration Sheet.

Obtain the TCP/IP address from the Configuration Sheet.

Update the lease time, if necessary, depending on your printer usage patterns.

If your network is using this protocol to assign TCP/IP addresses, be aware that the lease on the assigned address can run out if your printer is taken off the network for longer than the allocated lease time.

50 Quick Network Install Guide

Image 50
Contents DocuPrint Quick Network Install Guide Quick Network Install Guide Contents Contents Purpose of This Document Requirements Additional informationHow to Use this Document Printer System Administrator Guide to correctFound in the printer CD ROM Instruction booklet Windows 95/98 Peer-to-Peer NetworkNetworked Printers NextWindows 95/98 Peer-to-Peer Network Windows 95/98 Peer-to-Peer Network Quick Install Steps To change the group name in a NetBEUI-only network Type yes to confirm the monitor session Windows 95/98 Users Windows NT 4.x Network Introduction Preliminary StepsClick Add Port TCP/IP ProtocolAdd printer Wizard starts Click New Port Printer System Administrator Guide to correct Select the Hewlett-Packard Network Port Quick Install StepsDLC/LLC Protocol If the printer will not be shared, click Next. To share Port AppleTalk ProtocolSelect the AppleTalk Printing Devices and click New CD Drive\instal\winnt40 then click Open Windows 2000 Network Inside the Network and Dial-up Connections window Select Standard TCP/IP Port from the New Port Type Click in the Printer Name or IP Address edit box,Windows 2000 Network Windows 2000 Network DLC/LLC Protocol Select the Hewlett-Packard Network Port from the NewPage. Click Next Printer System Administrator Guide to correct Select the AppleTalk Printing Devices from the New Network and Dial-up Connections window and secectProperties Next Printer System Administrator Guide to correct Sheet Document in Appendix a Print The ConfigurationMacintosh EtherTalk Network Quick Setup Novell NetWare 3.1x, 4.1x NetworksPrinter System Administrator Guide to correct the problem Novell NetWare 3.1x, 4.1x, 5.x Networks OS/2 Warp Server LAN Server Network Are found in the Technical Information GuideOS/2 Warp V4.0 OS/2 Warp Connect Peer-to-Peer Network Unix Network IBM AIXAvailable on the Printer Management Software CD-ROM Go to Appendix B Set an IP Address and perform oneSunos and Solaris Refer to the CentreWare DP user Internet Printer Services Configure your Web Browser Appendix a Print Configuration Sheet For DocuPrint Networked PrintersPress Enter. The Configuration Sheet will be printed RARP/BOOTP Appendix B Set an IP AddressStatic Addressing Appendix B Set an IP Address Dynamic Addressing RARP/BOOTP Dynamic Addressing Dhcp Document entitled Appendix a Print The Configuration Sheet Dynamic Addressing Dhcp or RARP/BOOTP Arp -s x.x.x.x aa-aa-aa-aa-aa-aa CR Type Telnet x.x.x.x CRArpbypass set name 0x00.0x00.0x81.0xa.0xa.0xa AT&T and NCR X.x nameArp -s ether name 0081aaa no leading zeros RS-6000 Appendix B Set an IP Address Quick Network Install Guide
Related manuals
Manual 4 pages 48.38 Kb