Macintosh EtherTalk Network
Macintosh EtherTalk Network
Quick Install Steps | 1 Print the Configuration Sheet. Details are in this | |
|
| document in Appendix A: Print The Configuration |
|
| Sheet. |
| 2 | Check the Configuration Sheet and verify that EtherTalk |
|
| is enabled, the AppleTalk name is correct, the AppleTalk |
|
| zone is correct (if used), and the proper connector is |
|
| enabled. Details are in the Technical Information Guide. |
| 3 | Use the software installer to load print drivers. Details for |
|
| this are found in the your printer |
| 4 | Select your printer and zone (if used) in the Chooser. |
| 5 | Send a print job to the printer. |
| 6 | Check the print job for print quality. If print quality |
|
| problems exist, use the print quality section of your |
|
| printer System Administrator Guide to correct the |
|
| problem. |
| 7 | If your print job did not print, see the Troubleshooting |
|
| section for your operating system in the Technical |
Information Guide to correct the problem.