Xerox 3 manual Appendix B Set an IP Address, Rarp/Bootp

Page 45

Appendix B: Set an IP Address

Appendix B: Set an IP Address

Your printer can be set up on a variety of TCP/IP networks. There are several ways in which your printer can be assigned a TCP/IP address depending on your network.

Static Addressing	TCP/IP address is assigned
	manually by the System
	Administrator.
Dynamic Addressing	TCP/IP address is assigned
RARP/BOOTP	automatically by the Server.
Dynamic Addressing DHCP	TCP/IP address is assigned
(Dynamic Host Resolution	automatically by the Server.
Protocol)

This appendix contains procedures for each of these methods. Determine which method will be used for your network and follow the steps of the appropriate procedure.

Quick Network Install Guide ❖ 45

Image 45

Contents DocuPrint Quick Network Install Guide Quick Network Install Guide Contents Contents Requirements Additional information Purpose of This DocumentPrinter System Administrator Guide to correct How to Use this DocumentNetworked Printers Windows 95/98 Peer-to-Peer NetworkFound in the printer CD ROM Instruction booklet NextWindows 95/98 Peer-to-Peer Network Windows 95/98 Peer-to-Peer Network Quick Install Steps To change the group name in a NetBEUI-only network Type yes to confirm the monitor session Windows 95/98 Users Introduction Preliminary Steps Windows NT 4.x NetworkTCP/IP Protocol Add printer Wizard startsClick Add Port Click New Port Printer System Administrator Guide to correct Quick Install Steps DLC/LLC ProtocolSelect the Hewlett-Packard Network Port If the printer will not be shared, click Next. To share AppleTalk Protocol Select the AppleTalk Printing Devices and click NewPort CD Drive\instal\winnt40 then click Open Windows 2000 Network Inside the Network and Dial-up Connections window Click in the Printer Name or IP Address edit box, Select Standard TCP/IP Port from the New Port TypeWindows 2000 Network Windows 2000 Network Select the Hewlett-Packard Network Port from the New DLC/LLC ProtocolPage. Click Next Printer System Administrator Guide to correct Network and Dial-up Connections window and secect PropertiesSelect the AppleTalk Printing Devices from the New Next Printer System Administrator Guide to correct Document in Appendix a Print The Configuration Macintosh EtherTalk NetworkSheet Novell NetWare 3.1x, 4.1x Networks Quick SetupPrinter System Administrator Guide to correct the problem Novell NetWare 3.1x, 4.1x, 5.x Networks Are found in the Technical Information Guide OS/2 Warp Server LAN Server NetworkOS/2 Warp V4.0 OS/2 Warp Connect Peer-to-Peer Network IBM AIX Unix NetworkGo to Appendix B Set an IP Address and perform one Sunos and Solaris Refer to the CentreWare DP userAvailable on the Printer Management Software CD-ROM Internet Printer Services Configure your Web Browser For DocuPrint Networked Printers Appendix a Print Configuration SheetPress Enter. The Configuration Sheet will be printed Appendix B Set an IP Address RARP/BOOTPStatic Addressing Appendix B Set an IP Address Dynamic Addressing RARP/BOOTP Dynamic Addressing Dhcp Document entitled Appendix a Print The Configuration Sheet Dynamic Addressing Dhcp or RARP/BOOTP Type Telnet x.x.x.x CR Arp -s x.x.x.x aa-aa-aa-aa-aa-aa CRX.x name Arp -s ether name 0081aaa no leading zeros RS-6000Arpbypass set name 0x00.0x00.0x81.0xa.0xa.0xa AT&T and NCR Appendix B Set an IP Address Quick Network Install Guide

Related manuals

Manual 4 pages 48.38 Kb