2. LIST OF ERROR DISPLAY / INDICATION
Errors and warnings are displayed by the following ways:
1)Operator call errors are indicated by the Alarm LED lit in orange, and the error and its solution are displayed on the LCD in text and by icon.
2)Messages during printing from a computer are displayed on the MP driver Status Monitor.
3)Error codes are printed in the "operator call/service call error record" area in EEPROM information print.
Buttons valid when an operator call error occurs:
1)ON/OFF button: To turn the machine off and on again.
2)OK button: To clear and recover from an error. In some operator call errors, the error will automatically be cleared when the cause of the error is eliminated, and pressing the OK button may not be necessary.
3)Stop/Reset button: To cancel the job at error occurrence, and to clear the error.
2-1. Operator Call Errors (by Alarm LED Lit in Orange)
Error
No paper in the ASF.
No paper in the front feeder.
Error code
[1000]
[1003]
Message on the LCD Auto sheet feeder.
There is no paper. Load paper and press [OK].
Front feeder.
There is no paper. Load paper and press [OK].
Solution
Confirm that the ASF is selected as the paper source. Set the paper in the ASF, and press the OK button.
Confirm that the front feeder is selected as the paper source. Set the paper in the front feeder, and press the OK button.
Paper jam.
Paper jam in the rear guide.
No ink.
Ink tank not installed.
[1300]
[1303] [1600]
[1660]
The paper is jammed. Clear the paper and press 
[OK].
The following ink may have run out. Replacing the ink tank is recommended. (U041)
The following ink tank cannot be recognized. (Applicable ink tank icon) (U043)
Remove the jammed paper, and press the OK button.
Replace the empty ink tank(s), and close the cover.
Pressing the OK button will clear the error without ink tank replacement, however, ink may run out during printing.
Install the applicable ink tank(s) properly, and confirm that the LED's of all the ink tanks light red.
The print head is not installed, or it is not
properly installed.
Print head temperature sensor error
Faulty EEPROM data of the print head
Multiple ink tanks of the same color installed.
Ink tank in a wrong position.
[1401]
[1403]
[1405 / 1682]
[1681] 
[1680]
Print head is not installed. Install the print head.
The type of print head is incorrect. Install the correct print head.
More than one ink tank of the following color is installed. (U071)
Some ink tanks are not installed in place. (U072)
Install the print head properly.
print head.
Replace the wrong ink tank(s) with the correct one(s).
Install the ink tank(s) in the correct position.
Warning: The ink absorber becomes almost
full.
The connected digital camera or digital video camera does not support
Camera Direct Printing.
Failed in automatic print head alignment.
[1700 / 1701 /
1710 / 1711]
[2001]
[2500]
Contact the support center or service center for ink absorber replacement. Press [OK] to
continue printing.
Incompatible device detected. Remove the device.
Failed to scan head alignment sheet. Check orientation and position, and make sure platen
and sheet are clean. <See manual>
Replace the ink absorber, and reset its counter.
[See
Pressing the OK button will exit the error, and enable printing without replacing the ink absorber. However, when the ink absorber becomes full, no further printing can be performed unless the applicable ink absorber is replaced.
Remove the cable between the camera and the machine.
Press the OK button to clear the error, and perform automatic print head alignment again after confirming the following: