Star Micronics LC-6211 user manual Loading paper, Off O

Page 14

8Printer Setup

Set the switch on the front of the printer to ON to turn power on, and to OFF to turn power off.

ON I

OFF O

Important!

We recommend that you unplug the printer from the power outlet whenever you do not plan to use it for long periods. Because of the this, you should locate the printer so that the power outlet it is plugged into is nearby and easy to access.

At this point you may want to perform a test of the printer to make sure it is working properly. See “Testing the Printer” on page 32 for details on how to perform tests.

Loading paper

This section tells you how to load fanfold paper. Note that you can also use cut- sheet paper and multi-page form paper. For details on using other types of paper, see “Paper Handling” on page 25 of this manual.

Position the stack of paper behind the printer.

Unplug the printer from its AC power supply.

Image 14
Contents LC-6211 Trademark acknowledgments About this manual ChapterContents Using the Printer with MS-DOS … Paper Handling …Page Printer Setup Choosing a place for the printerPrinter Setup Unpacking the printerGeneral guide General guideInstalling the platen knob Opening the front coverInstalling the ribbon cartridge Installing the ribbon cartridgeRemoving the ribbon cartridge Connecting to a power outlet and turning power on and off Connecting to a power outlet and turning power on and offLoading paper OFF OLoading paper Sheet guide Loading paper Printing on fanfold paper Parking fanfold paperUnparking fanfold paper Using the tear-off functionUnparking fanfold paper Connecting to your computer Connecting to your computer Switching between on-line and off-line Control Panel OperationsPaper eject cut-sheet paper Paper loadingLine feed Form feed fanfold paperMicro feed Setting the top of form positionClearing a top of form setting Control Panel OperationsTear-off function Setting the printing speedSetting the printing speed Using the EDS Mode Category Setting OffEntering the EDS Mode Entering the EDS ModeGraphics Direction EDS Mode SettingsRAM Usage Tear-offPaper Out EDS Mode SettingsPrint Mode Line SpacingCharacter Table Banking CharacterZero style LengthCut-Sheet Paper Paper HandlingSelecting paper types Fanfold PaperAdjusting for paper thickness Paper HandlingAutomatic fanfold feeding Automatic fanfold feedingManual sheet feeding Fanfold Cut-sheet Release lever Manual sheet feeding Clearing paper jams Using the Printer with MS-DOS Setting up for printing with MS-DOSAppendix a Troubleshooting Testing the PrinterAdjusting the dot alignment Hexadecimal dumpProblem Possible Cause Troubleshooting guideTroubleshooting System software’s printer Printed on Ribbon is jammed Make sure that the ribbon Left margin moves to Paper is not loaded To check the application printer selection Checking system software settings in WindowsTo check the default printer selection Checking system software settings in MS-DOS To check the portAppendix B Specifications Printing Speed Pitch Draft cps/dpiEmulation Optional Serial Interface Appendix C Interface Pin OutsParallel Interface Appendix D Character Sets Character Set #1 International Character SetAppendix E Printer Control Codes Font and Character Set Control CommandsPrint Pitch Control Commands Printer Control CodesBit Image Graphic Commands Top/Bottom Margin and Vertical Tab CommandsSpecial Print Mode Commands Download Character Commands Line Spacing CommandsForm Feed and Related Commands Horizontal Print Position Control Commands Other CommandsAppendix F Glossary Parallel 14, 15, 40 length MS-DOS Page Customer service information