Star Micronics LC-6211 user manual Printing on fanfold paper, Parking fanfold paper

12Printer Setup

Printing on fanfold paper

When printing on fanfold paper, take care not to print too close to the perforations that separate each sheet. The following shows the recommended print area for fanfold paper and cut-sheet paper.

Fanfold paper

	4 mm (0.16")
18 mm	18 mm
(0.7")	(0.7")
Perforation	4 mm (0.16")
	4 mm (0.16")
Bottom of	6 mm (0.25")
Form

Cut-sheet paper

4 mm (0.16")

5 mm

(0.2")

6 mm (0.25")

5 mm (0.2")

Parking fanfold paper

It is not necessary to remove fanfold paper currently loaded in the printer in order to print on cut-sheet paper fed by hand. Instead, simply use the following procedure to park the fanfold paper.

❏Tear off the paper at a perforation so there is no more than half a page sticking out of the front cover of the printer.

If necessary, you can press the control panel’s ON LINE button to put the printer on-line. and then use the SET/EJECT/PARK button to feed the paper until a perforation is just past the front cover.

❏Press the control panel’s ON LINE button to put the printer off-line.

❏Press the control panel’s SET/EJECT/PARK button. The printer automatically reverse feeds the fanfold paper until it is no longer in contact with the platen.