Star Micronics LC-6211 user manual Installing the platen knob, Opening the front cover

Page 10

4Printer Setup

Installing the platen knob

The platen knob is packed into a recess in the packaging material.

❏Install the knob on the shaft located inside the large hole on the right side of the printer. Make sure that the flat side of the shaft is aligned with the corresponding flat surface inside the knob’s spindle. Press the knob carefully but firmly into place as far as it will go.

Opening the front cover

❏Hook your ﬁngers under the tw o small tabs on either side of the front cover and pull forward and up to swing the front cover open.

Front cover

Image 10

Contents LC-6211 Trademark acknowledgments About this manual ChapterContents Using the Printer with MS-DOS … Paper Handling …Page Printer Setup Choosing a place for the printerPrinter Setup Unpacking the printerGeneral guide General guideInstalling the platen knob Opening the front coverInstalling the ribbon cartridge Installing the ribbon cartridgeRemoving the ribbon cartridge Connecting to a power outlet and turning power on and off Connecting to a power outlet and turning power on and offLoading paper OFF OLoading paper Sheet guide Loading paper Printing on fanfold paper Parking fanfold paperUnparking fanfold paper Using the tear-off functionUnparking fanfold paper Connecting to your computer Connecting to your computer Switching between on-line and off-line Control Panel OperationsPaper eject cut-sheet paper Paper loadingLine feed Form feed fanfold paperMicro feed Setting the top of form positionClearing a top of form setting Control Panel OperationsSetting the printing speed Setting the printing speedTear-off function Using the EDS Mode Category Setting OffEntering the EDS Mode Entering the EDS ModeGraphics Direction EDS Mode SettingsRAM Usage Tear-offPaper Out EDS Mode SettingsPrint Mode Line SpacingCharacter Table Banking CharacterZero style LengthCut-Sheet Paper Paper HandlingSelecting paper types Fanfold PaperAdjusting for paper thickness Paper HandlingManual sheet feeding Automatic fanfold feedingAutomatic fanfold feeding Fanfold Cut-sheet Release lever Manual sheet feeding Clearing paper jams Using the Printer with MS-DOS Setting up for printing with MS-DOSAppendix a Troubleshooting Testing the PrinterAdjusting the dot alignment Hexadecimal dumpTroubleshooting Troubleshooting guideProblem Possible Cause System software’s printer Printed on Ribbon is jammed Make sure that the ribbon Left margin moves to Paper is not loaded To check the default printer selection Checking system software settings in WindowsTo check the application printer selection Checking system software settings in MS-DOS To check the portAppendix B Speciﬁcations Printing Speed Pitch Draft cps/dpiEmulation Parallel Interface Appendix C Interface Pin OutsOptional Serial Interface Appendix D Character Sets Character Set #1 International Character SetAppendix E Printer Control Codes Font and Character Set Control CommandsPrint Pitch Control Commands Printer Control CodesSpecial Print Mode Commands Top/Bottom Margin and Vertical Tab CommandsBit Image Graphic Commands Form Feed and Related Commands Line Spacing CommandsDownload Character Commands Horizontal Print Position Control Commands Other CommandsAppendix F Glossary Parallel 14, 15, 40 length MS-DOS Page Customer service information