Star Micronics LC-6211 user manual Paper loading, Line feed, Paper eject cut-sheet paper

Page 23

Paper loading 17

Paper loading

❏Prepare either cut-sheet or fanfold paper for feeding.

For details on how to prepare for paper feeding, see page 8 for fanfold paper and page 27 for cut-sheet paper.

❏The POWER indicator ﬂashes to indicate there is no paper in the printer.

❏Press SET/EJECT/PARK to feed the paper into the printer.

Line feed

❏Make sure the printer is off-line (ON LINE indicator is not lit).

❏Press LINE FEED once to feed paper one line. Holding down LINE FEED continually feeds paper, one line at a time, until you release the button.

Paper eject (cut-sheet paper)

❏Make sure the printer is off-line (ON LINE indicator is not lit).

❏Press SET/EJECT/PARK to eject the paper.

❏After the paper is ejected, the printer will beep and the POWER indicator will ﬂash to indicate there is no paper in the printer.

❏Later, you can press SET/EJECT/PARK again to feed the paper back into the printer.

Form feed (fanfold paper)

❏Make sure the printer is off-line (ON LINE indicator is not lit).

❏While holding down LINE FEED, press ON LINE to feed the paper to the top of the next page.

Image 23

Contents LC-6211 Trademark acknowledgments Chapter About this manualContents Paper Handling … Using the Printer with MS-DOS …Page Choosing a place for the printer Printer SetupUnpacking the printer Printer SetupGeneral guide General guideOpening the front cover Installing the platen knobInstalling the ribbon cartridge Installing the ribbon cartridgeRemoving the ribbon cartridge Connecting to a power outlet and turning power on and off Connecting to a power outlet and turning power on and offOFF O Loading paperLoading paper Sheet guide Loading paper Parking fanfold paper Printing on fanfold paperUnparking fanfold paper Using the tear-off functionUnparking fanfold paper Connecting to your computer Connecting to your computer Control Panel Operations Switching between on-line and off-lineForm feed fanfold paper Paper loadingLine feed Paper eject cut-sheet paperControl Panel Operations Setting the top of form positionClearing a top of form setting Micro feedTear-off function Setting the printing speedSetting the printing speed Category Setting Off Using the EDS ModeEntering the EDS Mode Entering the EDS ModeTear-off EDS Mode SettingsRAM Usage Graphics DirectionLine Spacing EDS Mode SettingsPrint Mode Paper OutLength Banking CharacterZero style Character TableFanfold Paper Paper HandlingSelecting paper types Cut-Sheet PaperPaper Handling Adjusting for paper thicknessAutomatic fanfold feeding Automatic fanfold feedingManual sheet feeding Fanfold Cut-sheet Release lever Manual sheet feeding Clearing paper jams Setting up for printing with MS-DOS Using the Printer with MS-DOSTesting the Printer Appendix a TroubleshootingHexadecimal dump Adjusting the dot alignmentProblem Possible Cause Troubleshooting guideTroubleshooting System software’s printer Printed on Ribbon is jammed Make sure that the ribbon Left margin moves to Paper is not loaded To check the application printer selection Checking system software settings in WindowsTo check the default printer selection To check the port Checking system software settings in MS-DOSPrinting Speed Pitch Draft cps/dpi Appendix B SpeciﬁcationsEmulation Optional Serial Interface Appendix C Interface Pin OutsParallel Interface Appendix D Character Sets International Character Set Character Set #1Printer Control Codes Font and Character Set Control CommandsPrint Pitch Control Commands Appendix E Printer Control CodesBit Image Graphic Commands Top/Bottom Margin and Vertical Tab CommandsSpecial Print Mode Commands Download Character Commands Line Spacing CommandsForm Feed and Related Commands Other Commands Horizontal Print Position Control CommandsAppendix F Glossary Parallel 14, 15, 40 length MS-DOS Page Customer service information