Star Micronics LC-6211 user manual Banking Character, Zero style, Character Table, Length

Page 30

24Using the EDS Mode

Banking Character

❏Enable or disable banking character font.

When the banking character is set to Enabled, the printer uses a special banking font to print the dollar sign and numerals 0 through 9. When set to Disabled, the special banking font is not used.

Zero style

❏Select the type of zero you want to use.

Selecting Normal prints zeros without lines running through them, while Slashed prints zeros with a diagonal slash running through them. Note that you can make this setting only when you are not using the special banking font (see Banking Character, above). The zero style of the special banking font overrides any setting you make here.

Character Table

❏Select the character table you want to use for printing.

For details on what characters are included in these character tables, see “Character Sets” on page 44 of this manual.

Page Length

❏Specify the length of the paper you are using.

Image 30

Contents LC-6211 Trademark acknowledgments About this manual ChapterContents Using the Printer with MS-DOS … Paper Handling …Page Printer Setup Choosing a place for the printerPrinter Setup Unpacking the printerGeneral guide General guideInstalling the platen knob Opening the front coverInstalling the ribbon cartridge Installing the ribbon cartridgeRemoving the ribbon cartridge Connecting to a power outlet and turning power on and off Connecting to a power outlet and turning power on and offLoading paper OFF OLoading paper Sheet guide Loading paper Printing on fanfold paper Parking fanfold paperUsing the tear-off function Unparking fanfold paperUnparking fanfold paper Connecting to your computer Connecting to your computer Switching between on-line and off-line Control Panel OperationsPaper eject cut-sheet paper Paper loadingLine feed Form feed fanfold paperMicro feed Setting the top of form positionClearing a top of form setting Control Panel OperationsSetting the printing speed Setting the printing speedTear-off function Using the EDS Mode Category Setting OffEntering the EDS Mode Entering the EDS ModeGraphics Direction EDS Mode SettingsRAM Usage Tear-offPaper Out EDS Mode SettingsPrint Mode Line SpacingCharacter Table Banking CharacterZero style LengthCut-Sheet Paper Paper HandlingSelecting paper types Fanfold PaperAdjusting for paper thickness Paper HandlingAutomatic fanfold feeding Manual sheet feedingAutomatic fanfold feeding Fanfold Cut-sheet Release lever Manual sheet feeding Clearing paper jams Using the Printer with MS-DOS Setting up for printing with MS-DOSAppendix a Troubleshooting Testing the PrinterAdjusting the dot alignment Hexadecimal dumpTroubleshooting guide TroubleshootingProblem Possible Cause System software’s printer Printed on Ribbon is jammed Make sure that the ribbon Left margin moves to Paper is not loaded Checking system software settings in Windows To check the default printer selectionTo check the application printer selection Checking system software settings in MS-DOS To check the portAppendix B Speciﬁcations Printing Speed Pitch Draft cps/dpiEmulation Appendix C Interface Pin Outs Parallel InterfaceOptional Serial Interface Appendix D Character Sets Character Set #1 International Character SetAppendix E Printer Control Codes Font and Character Set Control CommandsPrint Pitch Control Commands Printer Control CodesTop/Bottom Margin and Vertical Tab Commands Special Print Mode CommandsBit Image Graphic Commands Line Spacing Commands Form Feed and Related CommandsDownload Character Commands Horizontal Print Position Control Commands Other CommandsAppendix F Glossary Parallel 14, 15, 40 length MS-DOS Page Customer service information