Xantrex Technology PV-225208 Section Product Description Specifications, Equipment Symbol

Page 6

SECTION 1

PRODUCT DESCRIPTION

SPECIFICATIONS

The PV-225208 has been designed for photovoltaic power systems, which operate within the following speci- fications.Application of the PV-225208 in a manner inconsistent with these specifications may cause damage to the PV-225208 and other system components, and is a violation of the terms of the warranty.

Nominal AC Line Voltage

208

VAC, +10% -12%

 

 

 

Maximum AC Line Current

695

ARMS (at low line voltage)

 

 

Nominal Line Frequency

60 Hz, +0.5 -0.7 Hz

 

 

Continuous AC Output Power

225.0 kW @ 208 VAC 3 Phase

PV Maximum Voltage

600

VDC

 

 

Peak Power Tracking Window

330*-600 VDC

 

 

 

PV Minimum Peak Power Tracking Voltage

330

VDC

 

 

PV Maximum Operating Current

710 ADC

Maximum PV Array Short Circuit Current

1100 ADC

PV Configuration

Monopolar negative grounded

 

 

Operating Temperature

**-20 to 50° C

 

 

Storage Temperature

-40 to 50° C

 

 

Maximum Ambient Temperature Rating

50° C

 

 

Relative Humidity

To 95%, Non-condensing

 

 

Elevation

Derated above 6,600 feet

Dimensions (in inches)

87 X 102 X 27

 

 

Weight

Approx. 1935 lbs.

 

 

Enclosure Type

NEMA 3R

 

 

UL Listing File

File-E199356

 

 

 

*Dependent on actualAC line voltage. Refer to Section 4 for detail on the minimum power tracking voltage. **If ambient temperature is between -20 to 0° C, the unit must be powered up in standby for at least one hour prior to going on-line.

EQUIPMENT SYMBOL

Chassis ground – Customer supplied system ground connection point. This symbol may be found near a stud within the main enclosure. It is provided as a location to bond the electrical system equipment ground.

DOCUMENT: 151811

PV-225208 Photovoltaic Inverter

1-4

 

Operation and Maintenance Manual

 

Copyright 2003, Xantrex Technology Inc.

Image 6
Contents Manual Table of Contents Major Components Operation and Maintenance ManualSection Product Description Introduction Main EnclosureSection Product Description Control ComponentsPower Control Unit PCU Interconnection Standards ComplianceSection Product Description Specifications Equipment SymbolFault Reporting Section Safety Safety FeaturesMain Enclosure Door Interlock Switch PV Ground Fault DetectionOver/Under Voltage and Frequency Section SafetyIsolation Procedure Anti Island ProtectionTorque and Wire Gauge Specifications Utility Side Isolation Transformer RequirementsSection Installation and Initial TURN-ON Installation InstructionsInstallation Cable Entry Area Array Grounding Interconnection Wiring Ground Fault DetectionInterface PV-225208 Inverter Wiring Diagram Chassis Gnd TransformerPV Array Frame Ground DC Interface Circuit BreakerVisual Inspection, Isolation Transformer WYE/WYE Visual Inspection, PV Array WiringInitial Power Visual Inspection, PV-225208System Verification Power Tracker Fine Tuning Section Operation Description of System Operation OverviewOperating States Utility Voltage/Frequency Fault Automatic Reset Operation FeaturesFixed Unity Power Factor Operation Section OperationCurrent Imbalance Detection Peak Power TrackingOperator Interface DC Overvoltage DetectionSection Operation Manual State Transitions Commanding Goal State ChangesSetting the Date and Time Changing Write Parameter ValuesSleeping → Power Tracking → Sleeping Automatic State TransitionsAUTO-RESTART Feature TURN-ON ProcedureAny State → Fault Section Troubleshooting General Alarm and Fault ConditionsPV Overvoltage S Section TroubleshootingProgramming Mode S Bad Memory SAC Voltage Too Low S Door Interlock Switch Open HPV Auxiliary Switch Open H AC Voltage Too High SXX25/XX26 Line Gate Drive Fault S YY27/YY28 Line Over-Current Fault SPV Over-Current Fault S DC Bus Voltage High HSection Preventative Maintenance Periodic Maintenance Section Preventative Maintenance Section Appendix Faults Codes READ/WRITE Parameter MenuRead-Only Parameters Section Appendix Inverter StatesADC Warranty and Certification Drawings ListXantrex PV Series Limited Warranty and Registration Page Page Page Page Page Fab, Enclosure, Upper, 2 Bay, PV225208 Page Fab, Enclosure, DC Interface, PV225208 Page TB5 Source Control Specification