Fujitsu RX200 manual Opening the server, Removing the cover

Page 24

Opening the server

Preparation

In the majority of cases it makes sense to remove the server from the rack.

VCAUTION!

There is no cable management for the server in the rack! Before you remove the server from the rack, you must therefore unplug all cables connected to the server from their sockets.

IHow to remove the server from the rack is described in the operating manual.

Figure 3: Removing the cover

ÊUndo the knurled screw on the back of the device (see figure).

ÊPull the server cover back a few centimeters.

ÊLift up the server cover and remove it.

16	OptionsGuide

Image 24

Contents Primergy RX200 S2 Serversystem Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISOPage Page Abbreviations Related publications Index Page Contents Page Preface Overview of the documentationConcept and target groups Additional documentation about the serverOverview of the documentation Preface Further sources of informationAdditional accessible drives Extensions and conversionsSecond processor Extension of the main memoryRemoteView Service Board S2 LP RemoteViewNotational conventions Page Procedure Page Safety Instructions Before setting upInstallation and operation Page Batteries Modules with electrostatic-sensitive devices ESD labelPage Preparation Opening the serverOpening the server Removing the coverInstallation rules Main MemoryUpgrading / exchanging main memory Upgrading / exchanging main memoryInstalling a second processor ProcessorsInstalling a second processor Removing the ventilation ductInstalling the processor ProcessorsRemoving the heat sink dummy Vcaution Installing the heat sink Installing the ventilation ductExchanging the processor Exchanging the processorExchanging the processor Exchanging the processor Exchanging the heat sink Page Accessible Drives Installing the LocalView Module Installing the LocalView ModuleAccessible Drives Connecting the LocalView moduleInstalling a CD-ROM/DVD drive Installing a CD-ROM/DVD driveRemoving the dummy cover Installing a CD-ROM/DVD drive Installing the CD-ROM/DVD drive Installing a floppy disk drive Installing a floppy disk drive Removing/installing a floppy disk driveConnecting the data cable Page Controllers in Non-Hot-Plug PCI Slots Installing controllers Installing controllersInstalling a PCI board Removing the riser card holderReinstalling the riser card holder Mounting the boardPage Installing the RemoteView Service Board S2 LP RemoteView ComponentsRemove the slot cover Completion Closing the serverInstalling the server Closing the serverAbbreviations Abbreviations GAM LVD Rtds Page Related publications Integrated Mirroring User’s Guide Index Upgrade Comments Suggestions Corrections Page Comments Suggestions Corrections