Fujitsu RX200 manual Exchanging the processor

Page 34

Exchanging the processor

Processors

ÊApply a small amount of thermal paste to the top of the new processor.

ÊSpread the paste thinly and evenly.

ÊFit the heat sink on the processor such that the side labeled “FRONT” is facing the front of the server (see page 23).

ÊAttach the heat sink with four screws. Tighten the screws in diagonally opposite sequence (see page 23).

ÊReinstall the ventilation duct (see page 20).

ÊClose the server, plug in the power plugs, and switch on the server as described in the chapter “Completion” on page 45.

26

OptionsGuide

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Primergy RX200 S2 Serversystem Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISOPage Page Abbreviations Related publications Index Page Contents Page Concept and target groups PrefaceOverview of the documentation Additional documentation about the serverOverview of the documentation Preface Further sources of informationSecond processor Additional accessible drivesExtensions and conversions Extension of the main memoryRemoteView Service Board S2 LP RemoteViewNotational conventions Page Procedure Page Safety Instructions Before setting upInstallation and operation Page Batteries Modules with electrostatic-sensitive devices ESD labelPage Preparation Opening the serverOpening the server Removing the coverInstallation rules Main MemoryUpgrading / exchanging main memory Upgrading / exchanging main memoryInstalling a second processor ProcessorsInstalling a second processor Removing the ventilation ductProcessors Installing the processorRemoving the heat sink dummy Vcaution Installing the heat sink Installing the ventilation ductExchanging the processor Exchanging the processorExchanging the processor Exchanging the processor Exchanging the heat sink Page Accessible Drives Installing the LocalView Module Installing the LocalView ModuleAccessible Drives Connecting the LocalView moduleInstalling a CD-ROM/DVD drive Installing a CD-ROM/DVD driveRemoving the dummy cover Installing a CD-ROM/DVD drive Installing the CD-ROM/DVD drive Installing a floppy disk drive Installing a floppy disk drive Removing/installing a floppy disk driveConnecting the data cable Page Controllers in Non-Hot-Plug PCI Slots Installing a PCI board Installing controllersInstalling controllers Removing the riser card holderReinstalling the riser card holder Mounting the boardPage Installing the RemoteView Service Board S2 LP RemoteView ComponentsRemove the slot cover Completion Closing the serverInstalling the server Closing the serverAbbreviations Abbreviations GAM LVD Rtds Page Related publications Integrated Mirroring User’s Guide Index Upgrade Comments Suggestions Corrections Page Comments Suggestions Corrections
Top Page Image Contents