Fujitsu RX200 manual Preparation, Opening the server

Page 23

4 Preparation

VCAUTION!

Please observe the safety information in the chapter “Safety Instructions” on page 9ff.

4.1Opening the server

ÊExit all applications and shut down the server correctly.

ÊPress the on/off button.

ÊUnplug the power plugs.

1

2

1

Figure 2: Removing the server

ÊUndo the knurled screws (1) and pull the server carefully out of the rack (2) as far as possible.

OptionsGuide

15

Image 23

Contents Primergy RX200 S2 Serversystem Certified documentation according to DIN EN ISO Comments… Suggestions… Corrections…Page Page Abbreviations Related publications Index Page Contents Page Additional documentation about the server PrefaceOverview of the documentation Concept and target groupsFurther sources of information Overview of the documentation PrefaceExtension of the main memory Additional accessible drivesExtensions and conversions Second processorRemoteView RemoteView Service Board S2 LPNotational conventions Page Procedure Page Before setting up Safety InstructionsInstallation and operation Page Batteries ESD label Modules with electrostatic-sensitive devicesPage Opening the server PreparationRemoving the cover Opening the serverMain Memory Installation rulesUpgrading / exchanging main memory Upgrading / exchanging main memoryProcessors Installing a second processorRemoving the ventilation duct Installing a second processorRemoving the heat sink dummy Installing the processorProcessors Vcaution Installing the ventilation duct Installing the heat sinkExchanging the processor Exchanging the processorExchanging the processor Exchanging the processor Exchanging the heat sink Page Accessible Drives Installing the LocalView Module Installing the LocalView ModuleConnecting the LocalView module Accessible DrivesRemoving the dummy cover Installing a CD-ROM/DVD driveInstalling a CD-ROM/DVD drive Installing a CD-ROM/DVD drive Installing the CD-ROM/DVD drive Installing a floppy disk drive Removing/installing a floppy disk drive Installing a floppy disk driveConnecting the data cable Page Controllers in Non-Hot-Plug PCI Slots Removing the riser card holder Installing controllersInstalling controllers Installing a PCI boardMounting the board Reinstalling the riser card holderPage RemoteView Components Installing the RemoteView Service Board S2 LPRemove the slot cover Closing the server CompletionClosing the server Installing the serverAbbreviations Abbreviations GAM LVD Rtds Page Related publications Integrated Mirroring User’s Guide Index Upgrade Comments Suggestions Corrections Page Comments Suggestions Corrections