Fujitsu RX200 manual Remove the slot cover

Page 52

Installing the RemoteView Service Board S2 LP RemoteView Components

Low-profile slot (#2)

Figure 24: Installing the RSB S2 LP

ÊRemove the slot cover.

IKeep the slot cover for future use. If you remove the RSB S2 without installing a new one, you must reinstall the slot cover to comply with EMC regulations (regulations on electromagnetic compatibility) and to satisfy cooling requirements and fire protection measures.

ÊInstall the RSB S2 LP in the low-profile PCI slot (#2) of the riser card. The procedure is described in the section “Installing controllers” on page 40.

ÊPlug the power cable into the CN7 connector of the system board.

IThe position of the connectors is described in the “Technical Manual of the System Board D1790”.

ÊPlug the data cable into the CN6 socket (IPMB) of the system board.

ÊInstall the riser card holder (see page 41).

ÊClose the server, plug in the power plugs, and switch on the server as described in the chapter “Completion” on page 45f.

44	OptionsGuide

Image 52

Contents Primergy RX200 S2 Serversystem Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISOPage Page Abbreviations Related publications Index Page Contents Page Preface Overview of the documentationConcept and target groups Additional documentation about the serverOverview of the documentation Preface Further sources of informationAdditional accessible drives Extensions and conversionsSecond processor Extension of the main memoryRemoteView Service Board S2 LP RemoteViewNotational conventions Page Procedure Page Safety Instructions Before setting upInstallation and operation Page Batteries Modules with electrostatic-sensitive devices ESD labelPage Preparation Opening the serverOpening the server Removing the coverInstallation rules Main MemoryUpgrading / exchanging main memory Upgrading / exchanging main memoryInstalling a second processor ProcessorsInstalling a second processor Removing the ventilation ductProcessors Installing the processorRemoving the heat sink dummy Vcaution Installing the heat sink Installing the ventilation ductExchanging the processor Exchanging the processorExchanging the processor Exchanging the processor Exchanging the heat sink Page Accessible Drives Installing the LocalView Module Installing the LocalView ModuleAccessible Drives Connecting the LocalView moduleInstalling a CD-ROM/DVD drive Installing a CD-ROM/DVD driveRemoving the dummy cover Installing a CD-ROM/DVD drive Installing the CD-ROM/DVD drive Installing a floppy disk drive Installing a floppy disk drive Removing/installing a floppy disk driveConnecting the data cable Page Controllers in Non-Hot-Plug PCI Slots Installing controllers Installing controllersInstalling a PCI board Removing the riser card holderReinstalling the riser card holder Mounting the boardPage Installing the RemoteView Service Board S2 LP RemoteView ComponentsRemove the slot cover Completion Closing the serverInstalling the server Closing the serverAbbreviations Abbreviations GAM LVD Rtds Page Related publications Integrated Mirroring User’s Guide Index Upgrade Comments Suggestions Corrections Page Comments Suggestions Corrections