Fujitsu RX200 Installing controllers, Removing the riser card holder, Installing a PCI board

Page 48

Installing controllers

Controllers in Non-Hot-Plug PCI Slots

8.1Installing controllers

ÊOpen the server as described in the chapter “Preparation” on page 15f.

Removing the riser card holder

Figure 22: Removing the riser card holder

ÊUndo the two knurled screws (see figure).

ÊPull out the riser card holder upwards.

Installing a PCI board

ÊPlease read the documentation supplied with the PCI board.

ÊPlug any necessary cables into the PCI board.

ÊRemove the slot cover from the PCI board.

IKeep the slot cover for future use. If you remove the board without installing a new one, you must reinstall the slot cover to comply with EMC regulations (regulations on electromagnetic compatibility) and to satisfy cooling requirements and fire protection measures.

40	OptionsGuide

Image 48

Contents Primergy RX200 S2 Serversystem Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISOPage Page Abbreviations Related publications Index Page Contents Page Preface Overview of the documentationConcept and target groups Additional documentation about the serverOverview of the documentation Preface Further sources of informationAdditional accessible drives Extensions and conversionsSecond processor Extension of the main memoryRemoteView Service Board S2 LP RemoteViewNotational conventions Page Procedure Page Safety Instructions Before setting upInstallation and operation Page Batteries Modules with electrostatic-sensitive devices ESD labelPage Preparation Opening the serverOpening the server Removing the coverInstallation rules Main MemoryUpgrading / exchanging main memory Upgrading / exchanging main memoryInstalling a second processor ProcessorsInstalling a second processor Removing the ventilation ductInstalling the processor ProcessorsRemoving the heat sink dummy Vcaution Installing the heat sink Installing the ventilation ductExchanging the processor Exchanging the processorExchanging the processor Exchanging the processor Exchanging the heat sink Page Accessible Drives Installing the LocalView Module Installing the LocalView ModuleAccessible Drives Connecting the LocalView moduleInstalling a CD-ROM/DVD drive Installing a CD-ROM/DVD driveRemoving the dummy cover Installing a CD-ROM/DVD drive Installing the CD-ROM/DVD drive Installing a floppy disk drive Installing a floppy disk drive Removing/installing a floppy disk driveConnecting the data cable Page Controllers in Non-Hot-Plug PCI Slots Installing controllers Installing controllersInstalling a PCI board Removing the riser card holderReinstalling the riser card holder Mounting the boardPage Installing the RemoteView Service Board S2 LP RemoteView ComponentsRemove the slot cover Completion Closing the serverInstalling the server Closing the serverAbbreviations Abbreviations GAM LVD Rtds Page Related publications Integrated Mirroring User’s Guide Index Upgrade Comments Suggestions Corrections Page Comments Suggestions Corrections