SHC1300_booklet
ControlsInstallation
Transmitter (figure 1)
1IR transmitting LEDs – transmit audio signal to IR headphone.
2DC power – connect to the 12 Volt/ 200 mA AC/DC adapter.
3Power switch – power on/off switch.
43.5 mm stereo headphone audio input – connects your IR transmitter to an audio source.
5Controls plate Headphone (figure 2)
6IR sensors – to receive IR waves from the transmitter.
7Power indication – lights up when in use.
8Power On/Off – slide the switch to the on or off position to switch the headphone on/off.
9Volume – adjust volume to your desired listening level.
Transmitter power supply
IMPORTANT
Use only Philips SBC CS030/00 12 Volt/200 mA AC/DC adapter. (For UK, use only Philips SBC CS030/05)
1Make sure the adapter’s rated voltage corresponds to the mains socket voltage.
2Connect the DC connector of the AC/DC adapter to the 12 Volt DC power input connector located at the rear of the transmitter.
3Connect the 12 Volt/200 mA AC/DC adapter to the mains socket.
–Always disconnect the AC/DC adapter if the transmitter is not to be used for a long period of time.
Headphone power supply
1Check if the power button of the IR headphone is in the on position.
2Ensure the batteries are put in the battery compartment correctly according to the engraved polarity symbols.
Note:
Always remove the batteries if the headphone is not to be used for a long period of time.
Batteries contain chemical substances, so they should be disposed of properly.
English
Environmental Information
All redundant packing material has been omitted.We have done our best to make the packaging easily separable into two materials: cardboard and polyethylene.
Your unit consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment.
5