Cisco Systems ATA 188 manual Enable Fax Pass-through Mode, Run the following command

Chapter 7 Configuring and Debugging Fax Services

Using Fax Pass-through Mode

Note For detailed information on setting up your IOS gateways and on feature availability, refer to the document Cisco Fax Services over IP.

Enable Fax Pass-through Mode

The supporting Cisco gateway can enable fax pass-through mode using system-level or dial-peer-level commands.

System Level commands

Enable the fax pass-through feature using the following system-level commands:

Procedure

Step 1 Run the following command:

voice service voip

Step 2 Run the following command:

modem passthrough NSE [payload-type number] codec {g711∝/law g711alaw} [redundancy] [maximum-sessions value]

The definitions of the command parameters are as follows:

•The payload-typeparameter default is 100. Valid values are from 98 to 119.

The NSE payload number must be the same on both the Cisco ATA and the Cisco gateway.

•The codec parameter must be G.711∝−law for faxes sent over a T1 trunk or G.711A-law for faxes sent over an E1 trunk.

•The redundancy parameter enables RFC 2198 packet redundancy. It is disabled by default.

•The maximum sessions parameter defines the number of simultaneous fax pass-through calls with redundancy. The default is 16. Valid values are 1 to 26.

When using the voice service voip and modem passthrough nse commands on a terminating gateway to globally set up fax or modem pass-through with NSEs, you must also ensure that each incoming call will be associated with a VoIP dial peer to retrieve the global fax or modem configuration. You associate calls with dial peers by using the incoming called-numbercommand to specify a sequence of digits that incoming calls can match. You can ensure that all calls will match at least one dial peer by using the following commands:

Router(config)# dial-peer voice tag voip

Router(config-dial-peer)# incoming called-number .

Step 3 For the Cisco ATA ConnectMode parameter, turn off bits 14 and 15. This enables the sending of fax pass-through signals and the detection of incoming fax pass-through signals using the Cisco proprietary method.

Note The NSE payload-type number, fax pass-through codec (G.711∝-law or G.711A-law) and redundancy parameters must have the same settings for the Cisco ATA that they have for supporting Cisco gateways.

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (H.323)

7-4 OL-4008-01