Cisco Systems ATA 188 manual CallFeatures, Bit Number

Chapter 5 Parameters and Defaults

Operating Parameters

CallFeatures

		Description
		Disable/enable CallFeatures by setting each corresponding bit to 0 or 1.
		The lower 16 bits are for the Phone 1 port, and the upper 16 bits are for the Phone 2 port. Table 5-2
		provides definitions of each bit.
	Note	The subscribed features that can be permanently disabled by the user are CLIP_CLIR, call waiting and
		Fax mode. A subscribed service enable/disabled by the user can be disabled/enabled dynamically on a
		per-call basis.
		Value Type
		Bitmap
		Default
		0xffffffff
		Voice Configuration Menu Access Code
		314
		Related Parameters
		•	PaidFeatures, page 5-25
		•	CallCmd, page 5-46
		•	CallerIdMethod, page 5-26
Table 5-2 CallFeatures Parameter Bit Definitions
Bit
Number	Definition
0 and 16	Not used for H.323.
1 and 17	Not used for H.323.
2 and 18	Not used for H.323.
3 and 19	CLIP (if set to 1)/CLIR (if set to 0)
4 and 20	Call waiting
5 and 21	Three-way calling
6 and 22	Not used for H.323.
7 and 23	Not used for H.323.
8 and 24	Caller ID.
9 and 25	Not used for H.323.
10 and 26	Not used for H.323.
11 and 27	Call Waiting Caller ID.

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (H.323)

5-24 OL-4008-01