Chapter 4 Turn Up Node
DLP-D71 Create a 1:1 Protection Group
Purpose | This task creates a 1:1 electrical card protection group. |
Tools/Equipment | Redundant |
| installed in the shelf, or the ONS 15454 SDH slots must be provisioned for |
| two of these cards. |
Prerequisite Procedures | |
Required/As Needed | As needed |
Onsite/Remote | Onsite or remote |
Security Level | Provisioning or higher |
Step 1 Verify that the cards required for 1:1 protection are installed according to requirements specified in Table
Step 2 In node view, click the Provisioning > Protection tabs.
Step 3 Click Create.
Step 4 In the Create Protection Group dialog box, enter the following:
•
•
•Protect
After you choose the protect card, the card available for protection appears under Available Cards. If no cards are available, no cards appear. If this occurs, you can not complete this task until you install the physical cards or preprovision the ONS 15454 SDH slots using the
Step 5 From the Available Cards list, choose the card that will be protected by the card selected in the Protect Card
Step 6 Complete the remaining fields:
•Bidirectional
•
•Reversion
Step 7 Click OK, then click Yes on the confirmation dialog box.
Step 8 Return to your originating procedure (NTP).
| Cisco ONS 15454 SDH Procedure Guide, R4.6 |
January 2004 |