Cisco Systems 78-6897-01 manual Configuring the Router Purpose, Switch# show interface atm

Step Command

5Router(config-subif)# atm esi-addressaddress

6Router(config-subif)# end Router#

7(No command.)

Configuring the Router

Purpose

Configure a 14-digit ESI address on the subinterface (for example, 111111222222.00).

After ILMI address registration is complete, an NSAP address is automatically created based on the ESI address you entered.

Return to privileged EXEC mode.

Repeat this procedure on the other router.

Example

Router> enable

Router# configure terminal

Enter configuration commands, one per line. End with CNTL/Z. Router(config)# interface atm 0.1 multipoint Router(config-subif)# ip address 193.153.185.33 255.255.255.224 Router(config-subif)# atm esi-address 999999888888.00 Router(config-subif)# end

Router#

Verify

Switch# show interface atm 0.1

ATM0.1 is up, line protocol is up

Hardware is ATMizer BX-50

Internet address is 193.153.185.33/27

MTU 4470 bytes, BW 155520 Kbit, DLY 100 usec, rely 255/255, load 1/255 NSAP address: 47.0091810000000061E5BC01.999999888888.00

Encapsulation ATM

Switch#

Configuring SVCs, PVCs, SoftPVCs, PVPs, and VPTunnels 3-5