Configuring SVCs
If the SVC terminates on a router, however, configuration is required on the router where the SVC terminates. For your convenience, the router configuration is described in this section.
Figure3-1 shows an example network that illustrates how to set up SVCs. This example network is used throughout this section.
Figure3-1 Example Network for Configuring SVCs
Configuring the Router
Perform the following tasks on both routers that terminate the SVC:
•
•
•
•
Configure PVCs for QSAAL and ILMI signaling
Configure IP and ESI addresses and subnet masks
Determine the NSAP address
Configure a map group and map list
The following subsections describe these procedures in detail.
Tips Open two Telnet windows for both the source and destination routers.