Cisco Systems 78-6897-01 manual Configuring the Lecs Database Purpose

Step Command

6Switch(config)# atm address address

7Switch(config)# no atm address address

Configuring the LECS Database

Purpose

Configure a new ATM address.

Disable the old default ATM address.

Note Enter the show atm addresses command to display the default ATM addresses.

For examples of these commands, see the section “LANE Configuration Examples” at the end of this chapter.

Configuring the LECS Database

Take these steps:

Step Command

1Switch> enable Switch#

2Switch# configure terminal Switch(config)#

3Switch(config)# lane database database-name

4Switch(lane-config-database)# name elan-nameserver-atm-addressatm-address

5Switch(config)# name elan-nameserver-atm-addressaddress index n

Purpose

Enter privileged EXEC mode.

Enter global configuration mode.

Create a named database for the LECS.

In the configuration database, bind the name of the ELAN to the ATM address of the LES.

Note Enter the show lane default-atm-addressfor the ATM address of the server for the ELAN.

Specify redundant LES/BUSs, or simple server replication. Enter the command for each LES address for the same ELAN. The index determines the priority. Zero (0) is the highest priority.

Configuring LANE 4-7