Cisco Systems 78-6897-01 manual Configuring the Source ATM Switch Router, Switchconfig#

Configuring Soft PVCs

Verify

Not applicable.

Configuring the Source ATM Switch Router

Most of the configuration for the soft PVC occurs on the source switch. See the ATM switch router B in Figure3-3.

Take these steps:

Step	Command	Purpose
1	Switch# configure terminal	Enter global configuration mode.
	Switch(config)#

2Switch(config)# interface atm card/subcard/port

Switch(config-if)#

Enter interface configuration mode on the interface from which you want the soft PVC to originate (that is, the starting point).

3Switch(config-if)# atm soft-vcsrc-vpisrc-vcidest-addressdest_address dest-vpidest-vci

Enter the soft PVC VPI/VCIs for the interface on the source switch and the destination ATM address and destination VPI/VCIs.

4	Switch(config-if)# end	Return to privileged EXEC mode.
	Switch#
5	(No command.)	Proceed to the section “Configuring the
		Router” to complete the soft PVC.

Example

Switch# configure terminal

Switch(config)# interface atm 3/0/1

Switch(config-if)#atm soft-vc 0 50 dest-address

47.0091.8100.0000.0061.E5BC.0000.1111.11122.2222.00 1 60

Switch(config-if)# end

Switch#

3-16ATM Switch Router Quick Software Configuration Guide