Cisco Systems 78-6897-01 manual Switch# configure terminal Switchconfig#, Atm

Configuring PVPs

Take these steps:

Step Command

1Switch> enable Switch#

2Switch# configure terminal Switch(config)#

3Switch(config)# interface atm card/subcard/port

Router(config-if)#

4Switch(config-subif)# atm pvp vpi-Ainterface card/subcard/port vpi-B

5Switch(config-subif)# end Switch#

Purpose

Enter privileged EXEC mode.

Enter global configuration mode.

Enter interface configuration mode on the ATM interface.

Configure the PVP.

Note When configuring PVP connections, use the lowest available VPI numbers first.

Return to privileged EXEC mode.

Example

The following example shows how to configure the internal crossconnect (within the switch) PVP on ATM switch router B between interface 3/0/1, VPI = 2 and interface 3/0/2, VPI = 3:

Switch# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Switch(config)# interface atm 3/0/1

Switch(config-if)#atm pvp 2 interface atm 3/0/2 3

Switch(config-if)# end

Switch#

Verify

Switch# show	atm	vp
Interface	VPI	Type	X-Interface	X-VPI	Status
ATM3/0/1	2	PVP	ATM3/0/2	3	UP
ATM3/0/2	3	PVP	ATM3/0/1	2	UP
Switch#

3-20ATM Switch Router Quick Software Configuration Guide