Cabletron Systems BRIM-WT1 manual Related Manuals

Page 12

CHAPTER 1: INTRODUCTION

Safety and Approvals

This unit meets the safety requirements of UL 1950, CSA C22.2 NO 950, and EN 60950; the EMI requirements of FCC Class A and EN 55022 Class A; and the EMC requirements of EN 50082-1. The T1 port also meets FCC Part 68.

1.6RELATED MANUALS

Use the following manuals to supplement the procedures, and other technical data provided in this manual. This manual references procedures in these manuals, where appropriate, but does not repeat them.

Cabletron Systems’ MicroMMAC User’s Guide

Page 4

BRIM-WT1 USER’S GUIDE

Image 12

Contents Complete Networking Solution BRIM-WT1 USER’S GuidePage Page FCC Notice DOC NoticeCabletron SYSTEMS, INC Program License Agreement Cabletron Software Program LicenseExclusion of Warranty and Disclaimer Liability Contents Contents BRIM-WT1 USER’S Guide Using this Manual Chapter IntroductionBRIM-WT1 Features Getting HelpBRIM-WT1 Overview BRIM-WT1 Specifications Related Manuals Chapter Installation Unpacking the BRIM-WT1Installing the BRIM-WT1 Removing the Faceplate and Standoff ScrewsInstalling the BRIM-WT1 BRIM-WT1 USER’S Guide WAN Physical Configuration Screen Chapter Local ManagementActive WAN Port WAN Physical Configuration Screen Sample Timeslot Configuration Sample Configuration BRIM-WT1 USER’S Guide WAN Interface Configuration Screen PT# State Setting the Data Compression Field Setting the Line Coding Field BRIM-WT1 USER’S Guide Chapter Using the Lanview Leds BRIM-WT1 LedsT1/FT1 Port Leds Sync Port Leds BRIM-WT1 USER’S Guide