Cabletron Systems BRIM-WT1 manual Sample Timeslot Configuration

Page 20

CHAPTER 3: LOCAL MANAGEMENT

Setting WAN Physical Configuration Screen Fields

To set a WAN Physical Configuration screen field:

1.Use the arrow keys to highlight the WAN Physical Configuration screen field you want to change.

2.Press the Return key to toggle the selections.

3.When the desired selection appears, use the arrow keys to highlight the SAVE command.

4.Press the Return key or press F6. The message “Save Done!” appears and the changes are saved to memory.

Setting the T1 Timeslot Configuration Table

The T1 Timeslot Configuration Table allows you to configure how your MicroMMAC utilizes the T1 line. The configuration table consists of 24 Timeslots, which appear as 01-08, 09-16, and 17-24. You must assign each Timeslot an Interface number (03-26, or 00 if the Timeslot is not used). When you lease an entire T1 line, you can use all 24 Timeslots (the full T1 bandwidth). If you lease only a fraction of the T1, the Telco carrier will tell you which Timeslots to use.

You can utilize Timeslots any way you choose. For example, if your MicroMMAC has access to a full T1 (24 Timeslots), and you want to communicate with two other MicroMMACs, your configuration could look like figure 3-2.

MicroMMAC#1

24 Timeslots

MicroMMAC#2

16 Timeslots

Telco Cloud

MicroMMAC#3

8 Timeslots

Figure 3-2. Sample Timeslot Configuration

Page 12

BRIM-WT1 USER’S GUIDE

Image 20
Contents Complete Networking Solution BRIM-WT1 USER’S GuidePage Page FCC Notice DOC NoticeCabletron SYSTEMS, INC Program License Agreement Cabletron Software Program LicenseExclusion of Warranty and Disclaimer Liability Contents Contents BRIM-WT1 USER’S Guide Using this Manual Chapter IntroductionBRIM-WT1 Overview BRIM-WT1 FeaturesGetting Help BRIM-WT1 Specifications Related Manuals Chapter Installation Unpacking the BRIM-WT1Installing the BRIM-WT1 Removing the Faceplate and Standoff ScrewsInstalling the BRIM-WT1 BRIM-WT1 USER’S Guide WAN Physical Configuration Screen Chapter Local ManagementActive WAN Port WAN Physical Configuration Screen Sample Timeslot Configuration Sample Configuration BRIM-WT1 USER’S Guide WAN Interface Configuration Screen PT# State Setting the Data Compression Field Setting the Line Coding Field BRIM-WT1 USER’S Guide Chapter Using the Lanview Leds BRIM-WT1 LedsT1/FT1 Port Leds Sync Port Leds BRIM-WT1 USER’S Guide