Cabletron Systems manual Installing the BRIM-WT1

Page 15

INSTALLING THE BRIM-WT1

3.Position the BRIM-WT1 in the MicroMMAC as shown

in Figure 2-2. Ensure that the connector on the BRIM-WT1 sits flush on the MicroMMAC connector.

-WT BRIM

SYNC

		LNK
		DSR
		STB
		YEL
T1/FT1	LNK	TST
T1/FT1		CTS
		CTS
		SYN
		RED
	TST

Figure 2-2. Installing the BRIM-WT1

4.Secure the BRIM-WT1 to the standoffs and MicroMMAC rear panel using the four screws included with the module.

5.Reattach the chassis cover to the MicroMMAC and reconnect the MicroMMAC to your network.

BRIM-WT1 USER’S GUIDE

Page 7

Image 15

Contents BRIM-WT1 USER’S Guide Complete Networking SolutionPage Page DOC Notice FCC NoticeCabletron Software Program License Cabletron SYSTEMS, INC Program License AgreementExclusion of Warranty and Disclaimer Liability Contents Contents BRIM-WT1 USER’S Guide Chapter Introduction Using this ManualBRIM-WT1 Features Getting HelpBRIM-WT1 Overview BRIM-WT1 Specifications Related Manuals Unpacking the BRIM-WT1 Chapter InstallationRemoving the Faceplate and Standoff Screws Installing the BRIM-WT1Installing the BRIM-WT1 BRIM-WT1 USER’S Guide Chapter Local Management WAN Physical Configuration ScreenActive WAN Port WAN Physical Configuration Screen Sample Timeslot Configuration Sample Configuration BRIM-WT1 USER’S Guide WAN Interface Configuration Screen PT# State Setting the Data Compression Field Setting the Line Coding Field BRIM-WT1 USER’S Guide BRIM-WT1 Leds Chapter Using the Lanview LedsT1/FT1 Port Leds Sync Port Leds BRIM-WT1 USER’S Guide