Cabletron Systems BRIM-WT1 manual FCC Notice, DOC Notice

Page 4

NOTICE

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

DOC NOTICE

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

ii

Image 4
Contents Complete Networking Solution BRIM-WT1 USER’S GuidePage Page FCC Notice DOC NoticeCabletron SYSTEMS, INC Program License Agreement Cabletron Software Program LicenseExclusion of Warranty and Disclaimer Liability Contents Contents BRIM-WT1 USER’S Guide Using this Manual Chapter IntroductionGetting Help BRIM-WT1 FeaturesBRIM-WT1 Overview BRIM-WT1 Specifications Related Manuals Chapter Installation Unpacking the BRIM-WT1Installing the BRIM-WT1 Removing the Faceplate and Standoff ScrewsInstalling the BRIM-WT1 BRIM-WT1 USER’S Guide WAN Physical Configuration Screen Chapter Local ManagementActive WAN Port WAN Physical Configuration Screen Sample Timeslot Configuration Sample Configuration BRIM-WT1 USER’S Guide WAN Interface Configuration Screen PT# State Setting the Data Compression Field Setting the Line Coding Field BRIM-WT1 USER’S Guide Chapter Using the Lanview Leds BRIM-WT1 LedsT1/FT1 Port Leds Sync Port Leds BRIM-WT1 USER’S Guide