Cabletron Systems BRIM-WT1 manual

Page 3

NOTICE

NOTICE

Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.

The hardware, firmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

© Copyright February 1994 by:

Cabletron Systems, Inc., P.O. Box 5005, Rochester, NH 03867-0505

All Rights Reserved

Printed in the United States of America

Part Number: 9031024 February 1994

LANVIEW is a registered trademark of Cabletron Systems, Inc.

MicroMMAC and BRIM are trademarks of Cabletron Systems, Inc.

Windows is a registered trademark of Microsoft Corp.

Ethenet is a trademark of Xerox Corp.

CompuServe is a registered trademark of CompuServe

Printed On

Recycled Paper

i

Image 3
Contents BRIM-WT1 USER’S Guide Complete Networking SolutionPage Page DOC Notice FCC NoticeCabletron Software Program License Cabletron SYSTEMS, INC Program License AgreementExclusion of Warranty and Disclaimer Liability Contents Contents BRIM-WT1 USER’S Guide Chapter Introduction Using this ManualBRIM-WT1 Features Getting HelpBRIM-WT1 Overview BRIM-WT1 Specifications Related Manuals Unpacking the BRIM-WT1 Chapter InstallationRemoving the Faceplate and Standoff Screws Installing the BRIM-WT1Installing the BRIM-WT1 BRIM-WT1 USER’S Guide Chapter Local Management WAN Physical Configuration ScreenActive WAN Port WAN Physical Configuration Screen Sample Timeslot Configuration Sample Configuration BRIM-WT1 USER’S Guide WAN Interface Configuration Screen PT# State Setting the Data Compression Field Setting the Line Coding Field BRIM-WT1 USER’S Guide BRIM-WT1 Leds Chapter Using the Lanview LedsT1/FT1 Port Leds Sync Port Leds BRIM-WT1 USER’S Guide