Cabletron Systems BRIM-WT1 manual WAN Interface Configuration Screen

Page 23

THE WAN INTERFACE CONFIGURATION SCREEN

3.2THE WAN INTERFACE CONFIGURATION SCREEN

This section describes the features of the WAN Interface Configuration screen. To access the WAN Interface Configuration screen from the Features Selection screen, use the arrow keys to highlight the WAN Int. Config. option, then press the Return key. The WAN Interface Configuration screen shown in Figure 3-4 appears.

MicroMMAC/WT1 LOCAL MANAGEMENT

Cabletron MMW Revision xx.xx.xx

WAN INTERFACE CONFIGURATION

PT# IF# DLCI STATE PT# IF# DLCI STATE

Interface Number:

03

Data Compression: No

Max Xmit Unit:

1518

Line Coding:

Not Used

Active Protocol:

PPP

SAVE

WAN INT CONFIG

RETURN

-F6-

 

 

Figure 3-4. WAN Interface Configuration Screen

The following sections describe WAN Interface Configuration screen fields and instructions for setting them.

Interface Number

Displays Interface Numbers 02-26. Use this field to configure the Interface Numbers you assigned to the Timeslots at the WAN Physical Configuration screen. This field only displays the active SYNC and T1 interfaces.

Data Compression

Displays the status of Data Compression. Select Yes to activate Data Compression or No to de-activate. Data Compression is not supported at this time.

BRIM-WT1 USER’S GUIDE

Page 15

Image 23
Contents BRIM-WT1 USER’S Guide Complete Networking SolutionPage Page DOC Notice FCC NoticeCabletron Software Program License Cabletron SYSTEMS, INC Program License AgreementExclusion of Warranty and Disclaimer Liability Contents Contents BRIM-WT1 USER’S Guide Chapter Introduction Using this ManualBRIM-WT1 Overview BRIM-WT1 FeaturesGetting Help BRIM-WT1 Specifications Related Manuals Unpacking the BRIM-WT1 Chapter InstallationRemoving the Faceplate and Standoff Screws Installing the BRIM-WT1Installing the BRIM-WT1 BRIM-WT1 USER’S Guide Chapter Local Management WAN Physical Configuration ScreenActive WAN Port WAN Physical Configuration Screen Sample Timeslot Configuration Sample Configuration BRIM-WT1 USER’S Guide WAN Interface Configuration Screen PT# State Setting the Data Compression Field Setting the Line Coding Field BRIM-WT1 USER’S Guide BRIM-WT1 Leds Chapter Using the Lanview LedsT1/FT1 Port Leds Sync Port Leds BRIM-WT1 USER’S Guide