Cabletron Systems BRIM-WT1 manual Active WAN Port

Page 18

CHAPTER 3: LOCAL MANAGEMENT

The following sections describe WAN Physical Configuration screen fields and instructions for setting them.

Active WAN Port

Displays the active WAN port. In future MicroMMAC releases, this field will be used for port redundancy.

Default WAN Port

Displays the default WAN port used for the WAN connection. The selections are SYNC or T1.

Sync Port Type

Displays the Sync Port electrical interface type. The selections toggle between V.35, RS422, RS232, and NONE. This field always displays a Sync Port Type, even if the Sync Port is not the active WAN port. To use X.21 or RS530 select RS422 and use the proper Interface Cable available from Cabletron. See Table 1 for Cabletron Interface Cable part numbers. The default setting for this field is V.35.

Table 1: Cabletron Interface Cables

Interface Type

Cabletron Part

 

Number

 

 

 

 

V.35 (CCITT V.35)

9372080

 

 

RS422 (EIA 449)

9372078

 

 

RS232 (EIA 232)

9372079

 

 

X.21 (CCITT X.21)

Not Available

 

 

RS530 (EIA 530)

9372079

 

 

Force CTS True

Displays the source of the Clear To Send (CTS) signal. You can toggle the selections between YES and NO. The YES (On) setting indicates that the CTS is internally “Forced True” (from the BRIM-WT1).

The NO (Off) setting indicates that the CTS signal is received from an external DCE (Data Communications Equipment). The default setting is NO.

Page 10

BRIM-WT1 USER’S GUIDE

Image 18
Contents Complete Networking Solution BRIM-WT1 USER’S GuidePage Page FCC Notice DOC NoticeCabletron SYSTEMS, INC Program License Agreement Cabletron Software Program LicenseExclusion of Warranty and Disclaimer Liability Contents Contents BRIM-WT1 USER’S Guide Using this Manual Chapter IntroductionBRIM-WT1 Features Getting HelpBRIM-WT1 Overview BRIM-WT1 Specifications Related Manuals Chapter Installation Unpacking the BRIM-WT1Installing the BRIM-WT1 Removing the Faceplate and Standoff ScrewsInstalling the BRIM-WT1 BRIM-WT1 USER’S Guide WAN Physical Configuration Screen Chapter Local ManagementActive WAN Port WAN Physical Configuration Screen Sample Timeslot Configuration Sample Configuration BRIM-WT1 USER’S Guide WAN Interface Configuration Screen PT# State Setting the Data Compression Field Setting the Line Coding Field BRIM-WT1 USER’S Guide Chapter Using the Lanview Leds BRIM-WT1 LedsT1/FT1 Port Leds Sync Port Leds BRIM-WT1 USER’S Guide