Cabletron Systems manual Installing the BRIM-WT1, Removing the Faceplate and Standoff Screws

Page 14

CHAPTER 2: INSTALLATION

2.2INSTALLING THE BRIM-WT1

Caution: The BRIM-WT1 and the boards associated with the MicroMMAC are sensitive to static discharges. Be sure to use an antistatic wrist strap and observe all static precautions during this procedure. Failure to do so could result in damage to the BRIM-WT1 or the MicroMMAC.

To Install the BRIM-WT1 into the MicroMMAC:

1.Remove the screws from the BRIM slot faceplate at the rear panel of the MicroMMAC as shown in Figure 2-1.

2.Remove the screws from the two standoffs.

Standoff

Faceplate

MicroMMAC

Rear Panel

Figure 2-1. Removing the Faceplate and Standoff Screws

Page 6

BRIM-WT1 USER’S GUIDE

Image 14
Contents Complete Networking Solution BRIM-WT1 USER’S GuidePage Page FCC Notice DOC NoticeCabletron SYSTEMS, INC Program License Agreement Cabletron Software Program LicenseExclusion of Warranty and Disclaimer Liability Contents Contents BRIM-WT1 USER’S Guide Using this Manual Chapter IntroductionBRIM-WT1 Overview BRIM-WT1 FeaturesGetting Help BRIM-WT1 Specifications Related Manuals Chapter Installation Unpacking the BRIM-WT1Installing the BRIM-WT1 Removing the Faceplate and Standoff ScrewsInstalling the BRIM-WT1 BRIM-WT1 USER’S Guide WAN Physical Configuration Screen Chapter Local ManagementActive WAN Port WAN Physical Configuration Screen Sample Timeslot Configuration Sample Configuration BRIM-WT1 USER’S Guide WAN Interface Configuration Screen PT# State Setting the Data Compression Field Setting the Line Coding Field BRIM-WT1 USER’S Guide Chapter Using the Lanview Leds BRIM-WT1 LedsT1/FT1 Port Leds Sync Port Leds BRIM-WT1 USER’S Guide