Cabletron Systems BRIM-WT1 manual Setting the Line Coding Field

Page 27

THE WAN INTERFACE CONFIGURATION SCREEN

Setting the Line Coding Field

Before setting the Line Coding field, you must first set the T1 Line Coding field in the WAN Physical Configuration screen to OTHER.

To set the Line Coding field:

1.Use the arrow keys to highlight the Line Coding field.

2.Enter the desired setting.

3.Use the arrow keys to highlight the SAVE command.

4.Press the Return key or press F6. The message “Save Done!” appears. The BRIM-WT1 Local Management automatically assigns an Active Port Number to the Interface number and the changes are saved to memory.

BRIM-WT1 USER’S GUIDE

Page 19

Image 27
Contents BRIM-WT1 USER’S Guide Complete Networking SolutionPage Page DOC Notice FCC NoticeCabletron Software Program License Cabletron SYSTEMS, INC Program License AgreementExclusion of Warranty and Disclaimer Liability Contents Contents BRIM-WT1 USER’S Guide Chapter Introduction Using this ManualBRIM-WT1 Features Getting HelpBRIM-WT1 Overview BRIM-WT1 Specifications Related Manuals Unpacking the BRIM-WT1 Chapter InstallationRemoving the Faceplate and Standoff Screws Installing the BRIM-WT1Installing the BRIM-WT1 BRIM-WT1 USER’S Guide Chapter Local Management WAN Physical Configuration ScreenActive WAN Port WAN Physical Configuration Screen Sample Timeslot Configuration Sample Configuration BRIM-WT1 USER’S Guide WAN Interface Configuration Screen PT# State Setting the Data Compression Field Setting the Line Coding Field BRIM-WT1 USER’S Guide BRIM-WT1 Leds Chapter Using the Lanview LedsT1/FT1 Port Leds Sync Port Leds BRIM-WT1 USER’S Guide