EMC dimensions DS-xxB2 Rails Assembly

Page 11

Installing the DS-xxB2 Rails

Select the appropriate length rails, and follow the steps below to install them. The rails assembly consists of a front rail, an adjustable rear rail, and two washers and keps nuts. Figure 10 illusrates the complete assembly.

Keps Nut

(2)

#10 Flat Washer

(2)

Short

Rear

Rail

Front

Rail

		#10 Flat
Front	Short	Washer	Keps Nut
		(2)	Keps Nut
			(2)
Rail	Rear


	Rail		EMC2044S

Figure 10 DS-xxB2 Rails Assembly

EMC Departmental Switch DS-xxB2 Into Third-Party Racks

Image 11

Contents EMC Departmental Switch DS-xxB2 Guide for Installation of Switches Into Third-Party RacksDevice Device Model Mounting Kit Model OverviewDevice Device Power, Cooling, and Weight InformationDevice Dimensions Device Power Requirements Heat DissipationFront Rear Device Placement RequirementsUse Switch Mounting Kit DS16B2RKLSComponent Use Screws, Nuts and WashersTools Required Tools Required for InstallationRear Door Removed for Clarity Front Installing the DS-xxB2 RailsDS-xxB2 Short Rear Rails DS-xxB2 Rails InstallationFront Rails Screw Holes DS-xxB2 Rails Assembly Location of Keps Nuts Assembling the RailsSecuring the Keps Nuts Round-Hole ChannelInstalling Rails in Round-Hole Channels Square-Hole Channel Installing Rails in Square-Hole Channels Mounting Bracket Installation Installing the DS-xxB2 SwitchPlacing the Switch Into the Rack/Cabinet Installing the Switch in the Rack/CabinetM3 x 8-mm Pan Head Screw Tightening the Front and Rear Rail Assembly Screws Sales and Customer Service Contacts Where to Get HelpEMC Departmental Switch DS-xxB2 Into Third-Party Racks