EMC DS-xxB2 dimensions Square-Hole Channel

Page 15

Installing the DS-xxB2 Rails

Square-Hole Channel

To install the rails assembly in the square-hole channel of the rack/cabinet.

1.Align the holes of the front rail flange to the inside of the front channel. The top and bottom screw holes are used for the screws (see Figure 14 on page 16).

2.Secure the rail to a square-hole channel with two square-holewashers and M5 x 16-mm flat-head screws (see Table 5 on page 6). Leave the screws finger-tight, and tighten them after the switch is installed.

3.Align the holes in the rear, U-shaped flange of the rail with the holes in the rear inside channel, as shown in Figure 14.

4.Secure the rail to a square-hole channel with two square-hole washers and M5 x 16-mm flat head screws (see Table 5 on page 6). Leave the screws finger-tight, and tighten them after the switch is installed.

5.Repeat steps 1 through 4 for the other rail.

See instructions for Round-Hole Channel on page 13.

EMC Departmental Switch DS-xxB2 Into Third-Party Racks

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents EMC Departmental Switch DS-xxB2 Guide for Installation of Switches Into Third-Party RacksDevice Device Model Mounting Kit Model OverviewDevice Device Power, Cooling, and Weight InformationDevice Dimensions Device Power Requirements Heat DissipationFront Rear Device Placement RequirementsUse Switch Mounting Kit DS16B2RKLSComponent Use Screws, Nuts and WashersTools Required Tools Required for InstallationRear Door Removed for Clarity Front Installing the DS-xxB2 RailsDS-xxB2 Short Rear Rails DS-xxB2 Rails InstallationFront Rails Screw Holes DS-xxB2 Rails Assembly Location of Keps Nuts Assembling the RailsSecuring the Keps Nuts Round-Hole ChannelInstalling Rails in Round-Hole Channels Square-Hole Channel Installing Rails in Square-Hole Channels Mounting Bracket Installation Installing the DS-xxB2 SwitchPlacing the Switch Into the Rack/Cabinet Installing the Switch in the Rack/CabinetM3 x 8-mm Pan Head Screw Tightening the Front and Rear Rail Assembly Screws Sales and Customer Service Contacts Where to Get HelpEMC Departmental Switch DS-xxB2 Into Third-Party Racks
Top Page Image Contents