EMC DS-xxB2 Installing the Switch in the Rack/Cabinet, Placing the Switch Into the Rack/Cabinet

Page 18

Installing the DS-xxB2 Switch

Installing the Switch in the Rack/Cabinet

To install the switch in the rack/cabinet:

1.Lift and orient the switch so that the fan end is to the front of the rack/cabinet.

2.Align the bracket on each side of the switch with the “C” channel on each fixed rail.

3.Push the switch into the rack/cabinet until the hole in the front part of each bracket (the “L”-shaped end) aligns with the hole on the fixed rail.

EMC2049S

Figure 16 Placing the Switch Into the Rack/Cabinet

4.Secure the brackets to the rails with two M3 x 8-mm pan-head screws (see Table 5 on page 6), one on each side, (Figure 17 on page 19).

18

EMC Departmental Switch DS-xxB2 Into Third-Party Racks

Image 18

Contents

Guide for Installation of Switches Into Third-Party Racks EMC Departmental Switch DS-xxB2Overview Device Device Model Mounting Kit ModelDevice Power Requirements Heat Dissipation Device Power, Cooling, and Weight InformationDevice Dimensions DeviceDevice Placement Requirements Front RearSwitch Mounting Kit DS16B2RKLS UseScrews, Nuts and Washers Component UseTools Required for Installation Tools RequiredInstalling the DS-xxB2 Rails Rear Door Removed for Clarity FrontDS-xxB2 Rails Installation DS-xxB2 Short Rear RailsFront Rails Screw Holes DS-xxB2 Rails Assembly Assembling the Rails Location of Keps NutsRound-Hole Channel Securing the Keps NutsInstalling Rails in Round-Hole Channels Square-Hole Channel Installing Rails in Square-Hole Channels Installing the DS-xxB2 Switch Mounting Bracket InstallationInstalling the Switch in the Rack/Cabinet Placing the Switch Into the Rack/CabinetM3 x 8-mm Pan Head Screw Tightening the Front and Rear Rail Assembly Screws Where to Get Help Sales and Customer Service ContactsEMC Departmental Switch DS-xxB2 Into Third-Party Racks