EMC DS-xxB2 dimensions Tools Required for Installation

Page 7

Switch Mounting Kit (DS16B2RKLS)

Tools Required for Installation

You will need the tools shown in Figure 4 to complete the installation of the rails and one or more switches.

Tools Required:

	#1 Phillips	6-mm (1/4-in.)	8mm (5/16-in.)
	Screwdriver	Nut Driver	Nut Driver
			EMC2065
Figure 4	Tools Required for Installation

EMC Departmental Switch DS-xxB2 Into Third-Party Racks

7

Image 7

Contents

EMC Departmental Switch DS-xxB2 Guide for Installation of Switches Into Third-Party RacksDevice Device Model Mounting Kit Model OverviewDevice Device Power, Cooling, and Weight InformationDevice Dimensions Device Power Requirements Heat DissipationFront Rear Device Placement RequirementsUse Switch Mounting Kit DS16B2RKLSComponent Use Screws, Nuts and WashersTools Required Tools Required for InstallationRear Door Removed for Clarity Front Installing the DS-xxB2 RailsDS-xxB2 Short Rear Rails DS-xxB2 Rails InstallationFront Rails Screw Holes DS-xxB2 Rails Assembly Location of Keps Nuts Assembling the RailsSecuring the Keps Nuts Round-Hole ChannelInstalling Rails in Round-Hole Channels Square-Hole Channel Installing Rails in Square-Hole Channels Mounting Bracket Installation Installing the DS-xxB2 SwitchPlacing the Switch Into the Rack/Cabinet Installing the Switch in the Rack/CabinetM3 x 8-mm Pan Head Screw Tightening the Front and Rear Rail Assembly Screws Sales and Customer Service Contacts Where to Get HelpEMC Departmental Switch DS-xxB2 Into Third-Party Racks