EMC DS-xxB2 dimensions Round-Hole Channel, Securing the Keps Nuts

Page 13

Installing the DS-xxB2 Rails

Keps

Nut

Keps

Nut

EMC2045S

Figure 12 Securing the Keps Nuts

If the side skins are removed on the rack/cabinet, the keps nuts can be tightened after the rails have been installed.

Round-Hole Channel

To install the rails assembly in the round-hole channel of the rack/cabinet:

1.Align the holes of the front rail flange to the inside of the front channel. The top and bottom screw holes are used for the screws.

2.Secure the rail to a round-hole channel with 2 M5 x 10-mm pan- head screws (see table on Table 5 on page 6). Leave the screws finger-tight, and tighten them after the switch is installed. See Figure 13 on page 14.

3.Align the holes in the rear, U-shaped flange of the rail with the holes in the rear inside channel.

4.Secure the rail to a round-hole channel with 2 M5 x 10-mm pan- head screws (see table on Table 5 on page 6). Leave the screws finger-tight, and tighten them after the switch is installed. See Figure 13.

5.Repeat steps 1 through 4 for the other rail.

See instructions for Square-Hole Channel on page 15.

EMC Departmental Switch DS-xxB2 Into Third-Party Racks

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents EMC Departmental Switch DS-xxB2 Guide for Installation of Switches Into Third-Party RacksDevice Device Model Mounting Kit Model OverviewDevice Dimensions Device Power, Cooling, and Weight InformationDevice Power Requirements Heat Dissipation DeviceFront Rear Device Placement RequirementsUse Switch Mounting Kit DS16B2RKLSComponent Use Screws, Nuts and WashersTools Required Tools Required for InstallationRear Door Removed for Clarity Front Installing the DS-xxB2 RailsDS-xxB2 Short Rear Rails DS-xxB2 Rails InstallationFront Rails Screw Holes DS-xxB2 Rails Assembly Location of Keps Nuts Assembling the RailsSecuring the Keps Nuts Round-Hole ChannelInstalling Rails in Round-Hole Channels Square-Hole Channel Installing Rails in Square-Hole Channels Mounting Bracket Installation Installing the DS-xxB2 SwitchPlacing the Switch Into the Rack/Cabinet Installing the Switch in the Rack/CabinetM3 x 8-mm Pan Head Screw Tightening the Front and Rear Rail Assembly Screws Sales and Customer Service Contacts Where to Get HelpEMC Departmental Switch DS-xxB2 Into Third-Party Racks
Top Page Image Contents