EMC dimensions Installing the DS-xxB2 Switch, Mounting Bracket Installation

Page 17

Installing the DS-xxB2 Switch

Installing the DS-xxB2 Switch

This section describes the procedures for installing the DS-xxB2 switch in a rack/cabinet, including attaching the brackets on the switch.

Mounting Bracket Installation

You must attach mounting brackets to the switch before installing it on the rails. The mounting brackets slide into the “C” channel of the rails.

To attach the mounting brackets to the switch:

1.Orient the L-shaped end of the bracket outward and to the power outlet end of the switch.

2.Place the bracket against the switch. Align the three screw holes in the bracket with three screw holes on the side of the switch (see Figure 15 on page 17).

3.Secure the bracket with three 8-32 x 5/16-in. pan-head screws (see Table 5 on page 6). Tighten the screws fully.

4.Repeat steps 1 through 3 for the other side of the switch to be mounted.

Switch

Mounting

Bracket

#8-32 x 5/16-in. Pan Head Screw

(6)

Hole

Switch

Mounting

BracketEMC2048

Figure 15 Attaching the Switch Mounting Brackets

EMC Departmental Switch DS-xxB2 Into Third-Party Racks

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents EMC Departmental Switch DS-xxB2 Guide for Installation of Switches Into Third-Party RacksDevice Device Model Mounting Kit Model OverviewDevice Dimensions Device Power, Cooling, and Weight InformationDevice Power Requirements Heat Dissipation DeviceFront Rear Device Placement RequirementsUse Switch Mounting Kit DS16B2RKLSComponent Use Screws, Nuts and WashersTools Required Tools Required for InstallationRear Door Removed for Clarity Front Installing the DS-xxB2 RailsDS-xxB2 Short Rear Rails DS-xxB2 Rails InstallationFront Rails Screw Holes DS-xxB2 Rails Assembly Location of Keps Nuts Assembling the RailsSecuring the Keps Nuts Round-Hole ChannelInstalling Rails in Round-Hole Channels Square-Hole Channel Installing Rails in Square-Hole Channels Mounting Bracket Installation Installing the DS-xxB2 SwitchPlacing the Switch Into the Rack/Cabinet Installing the Switch in the Rack/CabinetM3 x 8-mm Pan Head Screw Tightening the Front and Rear Rail Assembly Screws Sales and Customer Service Contacts Where to Get HelpEMC Departmental Switch DS-xxB2 Into Third-Party Racks
Top Page Image Contents