Mounting
Your equipment may be rackmounted in 4-post rack enclosures using the included rack shelves (UPSRMRII Adjustable Rackmount Shelf Kit) and the following suggested mounting procedures. These procedures are for common enclosure types and may not be appropriate for all rack enclosures. You must determine the fitness of rackmount hardware and procedures before mounting. If this hardware or these procedures are not suitable for your application, contact your rack enclosure’s manufacturer for a solution.
Mount one piece of equipment in a 4-post rack section using the Single Unit Installation procedure, or one piece of equipment in a 2-post rack using the 2-Post (Telecom) Installation procedure. If you have two UPSRMRII shelf kits and a sufficiently deep rack, you may mount two pieces of equipment in a 4-post rack section using the Back-to-Back Installation procedure. Your UPS also may be positioned safely in an upright position without mounting screws with the addition of a 2U Tower Stand, sold separately from Tripp Lite.
Single Unit Installation
1Connect the two segments of each shelf (A) using the included screws and nuts (B). Leave the screws slightly loose so that the shelves can be adjusted in the next step.
2Adjust each shelf to fit your rack, then mount them in the lowest available space of your rack with the screws, nuts and washers provided (C). Note that the support ledges should face inward. Tighten the screws that connect the shelf segments (B).
3Attach mounting ears (D) to the front mounting holes of your equipment (E) using the screws provided (F). The ears should face forward.
4Using an assistant if necessary, lift your equipment and slide it onto the mounting shelves. Attach your equipment to the rack by passing the screws, nuts and washers provided (G) through its mounting ears and into the rack rails.