Sun Microsystems 1290 manual To Install the CMA-Lite, 18CMA-Lite Cable Management Arm

▼To Install the CMA–Lite

1.Secure the pivot at the end of the upper arm to the top rear of the server, using the two captive screws (FIGURE 1-18).

2.Secure the center pivot point of the CMA to the inside rear of the left hand slide rail assembly, using the two captive screws.

3.Secure the pivot at the end of the lower arm to the bottom rear of the server, using the two captive screws.

Captive screws (2)

CMA-LIte

Captive screws (2)

Captive screws (2)

FIGURE 1-18CMA–Lite Cable Management Arm

Chapter 1 Unpacking and Installing the Server 25