Sun Microsystems 1290 manual Installing the Cable Management Arm

Installing the Cable Management Arm

This section contains the following topics:

■“To Install the CMA–Lite” on page 25

■“To Install the CMA–800” on page 26

The cable management arm (CMA) supports and protects cables when a server slides into or out of a cabinet.

Two cable management arm solutions are offered – CMA-Lite and CMA-800. The choice of CMA depends on the available depth in the cabinet and the quantity or type of cable to be supported. Use the CMA-Lite if the larger CMA-800 management arm does not fit your cabinet.

Threaded holes for attaching the CMA are provided on the rear of the server (FIGURE 1-17).

Upper bracket holes

PCI 0	PCI 1	PCI 2	PCI 3	PCI 4
33MHz	33MHz	33MHz	33MHz	33MHz
SSC1	SerialB B	SSC1
SerialA A

AC

3

SOURCE AB

AC

2

AC

1

SOURCE A

AC

0

Lower bracket holes

SCSI3

66MHz	ALARMS
PCI 5
	Link
	Active
	NET
	0
	GBit
	Link
	Active
	NET
	1
	GBit

FIGURE 1-17CMA Bracket Mounting Holes

24 Netra 1290 Server Installation Guide • May 2006