Sun Microsystems 1290 manual To Configure Network Parameters, At the LOM prompt, type setupnetwork

2.At the Enter new password prompt, type your password.

3.At the Enter new password again prompt, re-type your password.

lom>password

Enter new password: Enter new password again: lom>

If your password has been lost or forgotten, contact Sun Service for assistance.

▼To Configure Network Parameters

The Netra 1290 server can be administered from the SC LOM prompt and from the Solaris software. There are two ways to access the LOM console connection:

■Through the SC serial port connection

■Through a remote (network) connection using the 10/100BASE-T Ethernet port

Note – The system can be administered solely through the serial port, but if you want to use the 10/100BASE-T Ethernet port, use a separate secure subnet for this connection. Remote connection capability is not enabled by default. If you use SSH or Telnet to administer the system, you must set the connection type to SSH or Telnet, using the setupnetwork command.

1. At the LOM prompt, type setupnetwork.

lom>setupnetwork

2.Answer the questions in the script.

Note – If you press the Return key after each question, the current value will not be changed.

See the Sun Fire Entry-Level Midrange System Controller Command Reference Manual, 819-1268 for full details of the setupnetwork command. CODE EXAMPLE 2-1shows an example of the setupnetwork command.

Chapter 2 Setting Up 45