Sun Microsystems 1290 manual Setting Up the Hardware, On/Standby Switch

FIGURE 2-1

FIGURE 2-1

8.Booting the Solaris Operating System.

9.Installing the Lights Out Management packages from the Sun Microsystems software download center.

Setting Up the Hardware

▼To Install and Cable the Hardware

1.Connect a terminal to the system controller board serial port (FIGURE 1-26).

2.Set up the terminal to use the same baud rate as the SC serial port. The serial port settings of the System Controller board are:

■9600 baud

■8 data bits

■No parity

■1 stop bit

On/Standby Switch

The On/Standby switch is a rocker switch with two positions, On and Standby. illustrates the switch and its location.

On/Standby switch

Netra 1290 Server On/Standby Switch

40 Netra 1290 Server Installation Guide • May 2006